Advertisement
IMPORTANT
Read the instructions thoroughly before using your digital safe.
Keep codes in a safe place. Do not use personal information like birthdays,
telephone numbers etc.
Keep keys and backup power supply in a safe place but not in the safe itself!
If the safe is not to be used for a long time, take out the batteries.
Dia 1
Lock knob
SPECIFICATION
SIZE
: 350mm(W) X250mm(H) X250mm(D)
NET WEIGHT
: 9.5Kgs
POWER SUPPLY : 4XAA/1.5V Batteries
CONTENTS
1 X Backup power supply
2 X Manual override keys
4 X Fixing bolts
1 X Internal mat
1 X Instruction book
-1-
LCD display
Number
pad
Key Lock Cover
OPERATING THE SAFE FOR THE FIRST TIME
1. Use the Manual override key to open the safe for the first time, remove the plastic key
lock cover (Dia 1). Insert the override key, turn to the left at the same time turn the safe
handle to the right and open the safe.
2. Install the 4 X AA type battery's supplied, in the back of the safe door, as shown in Dia 9
3. While the door is open familiarise yourself with the door opening procedure, To open the
safe for the first time , press "#" then enter the
code "1234" (which is the factory default code)
then press "#" again. The safe will beep 3 times
and display "OPEN". Then turn the knob
clockwise within 10 seconds to open the safe.
Dia 3
4. If the code is entered incorrectly the "LCD" will
display "ERROR"
5. Refit the plastic key cover and place the
override keys in a safe place (NOT IN THE
SAFE) for emergency use.
Note: In addition to the user code, your safe also has a
master code "123456" set by the factory. User code can
be used as guest-code in the hotel-trade.
SETTING YOUR OWN USER OR MASTER CODE
1. Press "#" then the correct user code or master code then press "#" again. The safe will
beep 3 times and display "OPEN".
2. Press "
" within 10 seconds and the LCD will display "------".
*
3. Enter the new user or master code and press"#",then the LCD will display "------" once again,
repeat your code and "#", the LCD will display "IN"
Note: The steps above will only change one code (the user or the master) based on the code
you entered in step 1. To change the other code simply repeat the the steps above using the
other code at step 1.
LCD DISPLAY
1. To hide the LCD display, enter "#" then enter "
on the LCD readout.
2. If a mistake is made when inputting the code press "
RESET FUNCTION
The safe can be reset back to the factory default codes
by pressing the red button situated on the inside cover
of the safe door.(Dia 4).
To gain access to reset button you must first remove
the reset button cap.
After pressing the red reset button the display
will show "CLEAR" and all codes revert back to
the factory default codes.
Please refit reset button cap back for security reasons.
Dia 2
Override keys
Backup power supply
Dia 3
" followed by the code. The code will not display
*
", the last digit entered will be deleted.
*
Dia 4
Reset
button
-2-
Advertisement
