Stuff 4 Multiples TwinTrexx 2 Instructions And Care

Twin baby carrier

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Thank you for choosing a Stuff 4 Multiples product. For safety and ease of use, please review all

Instructions For Use, as well as product care information prior to using carrier. In an effort to continuously

improve our products, the actual carrier may vary slightly from the images in the instructions.

Care Instructions:

Hand washing will prolong the life of your TwinTrexx 2® baby carrier

Do not dry clean

Do not bleach

Do not iron

Air dry only-do not use electric dryer

Avoid prolonged exposure to sunlight (car, etc). Product fabric may fade.

Avoid prolonged exposure to excessive humidity and/or high temperatures.

Twin Baby Carrier

Instructions and Care

TwinTrexx 2®

Twin Baby Carrier

Table of Contents

Need help?

Do you have a question about the TwinTrexx 2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Stuff 4 Multiples TwinTrexx 2

Page 1 TwinTrexx 2® Twin Baby Carrier Thank you for choosing a Stuff 4 Multiples product. For safety and ease of use, please review all instructions for use, as well as product care information prior to using carrier. In an effort to continuously improve our products, the actual carrier may vary slightly from the images in the instructions.
Page 2 Pick up one carrier and lift to one side of chest, with the TwinTrexx2 ® logo facing out and the TwinTrexx 2® logo that is upside down facing your body. Place both unfastened arm straps over the same shoulder toward the opposite hip.
Page 3 Connect the two buckles at the front. (The buckles in the front will connect leaving one female end open in the front and one male end buckle unattached closest to your body.) (See Figure 2) Figure 2 At this time, make any adjustments if the carrier is riding too high or too low and tighten straps as necessary.
Page 4 Follow the inward instructions and make sure to fold the front flap and button it so that the upside down TwinTrexx 2 logo is now facing outward. Sit on a soft flat surface (such as a bed-or a couch with secured car seats near you), and safely place your babies next to you (where they are not in danger of rolling off).
Page 5 For wearing the single carrier in the front position, take the carrier and hold it to your chest. To have the child face outward, make sure the TwinTrexx 2® logo is facing outward while the backwards logo faces you. Close the snap on the front of the carrier so that logo that is inside (backwards) is now facing forward.
Page 6 Bending at the knees with your back to your baby, pull the carrier onto your shoulders as you would with a standard backpack. Straps will not cross on rear carrier. Adjust straps as needed for optimal support and comfort. Unloading in the Front-Out & Back-In Twin Position Sit on a soft flat surface (such as a bed), and use one arm to hold the front riding child snugly.
Page 7 THE CARRIER SHOULD NOT BE USED WHEN JOGGING, CLIMBING, BIKING, OR PARTICIPATING IN OTHER SPORTING OR STRENUOUS ACTIVITIES. HANDS SHOULD ALWAYS BE AVAILABLE TO CHECK AND ADJUST BABY’S POSITION. INSPECT THE BABY CARRIER REGULARLY FOR ANY SIGNS OF WEAR AND TEAR, ESPECIALLY AROUND STRAPS, SAFETY ELASTIC LOOPS, BUCKLES AND SEAMS.