Programming The Remote Control For Use With A Non-Toshiba Vcr Or Cable Tv Converter - Toshiba 42H82 Owner's Manual

To control a cable TV converter:
Program the remote control to recognize the brand of your
converter. The shaded buttons shown at right will control the
cable TV converter.
Set the TV/CABLE/VCR switch to the CABLE position.
Programming the remote control for use with a
non-Toshiba VCR or cable TV converter
This remote control is pre-programmed to operate Toshiba VCRs. To
use VCRs or cable converters other than Toshiba models, you must
follow the steps below before you operate your remote control.
1. Refer to the "VCR code table" or "Cable TV converter code
table" on pages 17–18 to find the number that corresponds to the
brand name of your VCR or converter.
If more than one number is listed, try each one separately until
you find the one that works.
2. If you are reprogramming the remote control to operate your:
• VCR, set the TV/CABLE/VCR switch on the remote control
to VCR.
• Cable converter, set the TV/CABLE/VCR switch on the
remote control to CABLE.
3. While holding down the RECALL button, press the Number
buttons (0-9) to enter the three-digit code of your brand of VCR
or converter.
4. Point the remote control at the VCR or converter and press
POWER to test the code.
If the VCR or converter turns on, you have entered the correct
code.
If the VCR or converter does not respond to the remote control,
you may have entered the wrong code. Repeat steps 1-4 with
another code.
5. Reset the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code numbers you used:
VCR code _____________________
Cable code _____________________
16
RECALL
LIGHT RECALL POWER
POWER
TV
CABLE
MUTE TV/VIDEO TIMER
VCR
1 2 3
Channel yz
CH
4 5 6
Channel
7 8 9
Number
VOL
CH RTN
0
100
ENT
Enter
ADV/
POP CH
MENU/
FAV FAV
ENTER
ADV/
POP CH
STOP SOURCE PLAY PIP
REC TV/VCR REW FF
Note:
STILL LOCATE SWAP
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2. "
If your VCR has this kind of switch, it may
not respond to any of the code numbers for
your VCR brand name. In this case, set the
switch to the other position (VCR1 or
VCR2) and reprogram the remote control.