SALONPRO Multi-Zone Hair Color Processor User Manual page 5

2
To install the Wall Mounting Bracket on a brick,
block or concrete wall:
• Hold the bracket in place and use a level to
ensure it is perfectly vertical.
• Mark the three screws holes.
• Drill holes with a 3/8 in (l 0.5 mm) diameter,
and 2.5 in (65 mm) depth, into the brick or
block wall.
• Insert the anchor-bolts with the sleeves, nuts
and washers attached.
• Remove the nuts and washers and mount the
bracket onto them.
• Replace the washers, lock-washers and nuts in
that order.
• Tighten with a wrench to an appropriate
Attaching and Adjusting the Swing-Arm and Dryer.
1
With the Wall Bracket in place and secured:
• Slide the open end of the Swing Arm onto
the bracket and slide into place with a little
downward pressure.
Note: The Swing Arm is spring loaded to
compensate for the weight of the Dryer and will
not adjust properly until the Dryer is attached.
2
To attach the Dryer:
i. Remove the small Phillips lock-screw above
the release ring.
1.
ii. Hold the Dryer in place, and on the
attachment-point of the Swing Arm, pull
the release-ring up until the ball-clip is
revealed.
2.
iii. Slide the attachment post on the dryer into
the attachment-point of the Swing Arm,
until the ball-clip aligns with the groove on
attachment post on the dryer.
iv. The release clip may now be returned to its
original position, locking the attachment
post in place.
4.
v. Replace the locking screw.
5.
vi. With the Dryer attached, test for free and
easy movement of the Swing Arm.
3
• Connect the Power Cable
Note: In some cases, it may be necessary to
adjust the counterbalance mechanism or the
Max/Min height adjustments on the Swing Arm.
See instructions in the next section.
Note: It is important to inspect the Wall Bracket
and attachments on a regular basis to ensure
proper and safe operation.
1.
3.
5.
2.
3.
4.