Kelkay EasyFountain 45020L Instructions

Easy Fountain Instructions
45020L Rustic Pump Pots
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.

STAGE 1

Position the water feature onto a secure and level surface.

STAGE 2

Following the diagram above, fix the water pump section of the feature onto the base and secure it
into position.

STAGE 3

Position the pump in the resevoir at the base of the fountain and attach the LED light to the cable
that extends from the pump. Connect the internal water pipe to the pump outlet.

STAGE 4

Thread the long transformer wire through the opening in the back of the fountain. Push the cable
with 2 pins into the transformer and screw over the plastic collar.

STAGE 5

Carefully fill the fountain with sufficient water taking care to ensure the pump is fully submerged.

STAGE 6

Connect the plug to your mains outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
Pump FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.