Advertisement
Advertisement
Table of Contents
Summary of Contents for Whale Spa Deluxe 1
- Page 1 Owners Manual...
- Page 2 SPECIFIC LEGAL RIGHTS. THE CUSTOMER MAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY BY EACH JURISDICTION. Should your Pedicure Spa require service due to a defect or malfunction, please contact: Whale Spa – Technical Support 1-866-573-3727 fax: 213-485-8310 email: WhaleSpa@gmail.com...
- Page 3 Whale Spa Owner’s Manual Whale Spa Owner’s Manual Whale Spa: Whale Spa: • Deluxe # 1 • Deluxe # 1 • Harmony # 7 • Harmony # 7 • WS 400 Renalta • WS 400 Renalta • WS 500 Acacia •...
- Page 4 Putting your Whale Spa Pedicure Chair Together Step 1. Place the pedicure chair base near the location where it will be installed. Step 2. Screw the massage chair on to the base. Step 3. Attach the drain pipe to the drain system.
-
Page 5: Important Requirements
Introduction The Whale Spa pedicure chairs (herein referred to as pedicure spa) are innovative pedicure spas that have been designed to serve you dependably for many years. Please take time to thoroughly read this entire manual before installation and use. If you have any problems or have questions regarding your pedicure spa, please contact Whale Spa’s Technical Support Department at 1-866-573-3727,... - Page 6 DANGER 1) Never use pins or other metallic fasteners with this appliance. 2) Carefully examine the covering before each use. 3) Discard the appliance if the covering shows any sign of deterioration, such as checking, blistering, or cracking. 4) Keep Dry – Do not operate in a wet or moist condition. WARNING 1) WARNING: RISK OF ELECTRIC SHOCK;...
-
Page 7: Important Installation And Utility Information
Important Installation and Utility Information Electrical Service: 110V: A 110V, 60 Hz, 15 Amp GFCI protected grounded circuit must be used to supply power to the pedicure spa. (220V if ordered in 220V configuration) Water Supply: All plumbing connections must conform to local codes. Normal water pressure of 30 to 80 PSI is required to correctly fill the basin to the proper level. - Page 8 such on soap product) and water. Rinse with clean water. (4) Re-insert the properly cleaned inlet housing & impeller. (5) Refill the basin with clean water and circulate the correct amount (read the label for mixing instruc- tions) of the EPA-registered hospital-liquid disinfectant which the label claims is a bactericide, fungi- cide, and virucide, through the basin for at least 10 minutes.
-
Page 9: Installation
INSTALLATION Place the pedicure chair at least 16” from the wall and on a level and stable surface. Hot and cold water supply line fittings are 1/2” and are located at the rear of the unit. Drain can be extended with a 1 1/2” PVC pipe. Use of a floor sink is recommended. The electrical outlet used to supply power to each pedicure chair must be 110V, 60Hz, 15 Amp GFCI protected and grounded. -
Page 10: Troubleshooting
TROUBLESHOOTING Troubleshooting Guide for Whale Spa Pedicure Spa’s Base surface If the surface of the base is discolored The color has probably been affected because of direct contact with chemicals to the basin. When prolonged exposure to bleach, barbicide, acetone or other strong chemicals, it may affect your pedi- cure spa base. - Page 11 Check to see where exactly the water is leaking from then call local dealer or 1-866-573-3727 for assistance. Problems relating to your Whale Spa Pedicure Spa Massage rollers are not working. Check the power source and all other connections to ensure that all the plugs are in the right place.
- Page 12 position. Massage rollers are not Kneading or tapping Call local dealer or 1-866-573-3727 for assistance. Chair does not recline. Check if the safety pin is inserted properly. If you have more than one of the same pedicure spas, then replace the remote for recliner. If the remote for recliner did not solve the problem, then replace the control box.
Need help?
Do you have a question about the Deluxe 1 and is the answer not in the manual?
Questions and answers
the discharge stops before basin is empty, and it has to be restarted. Why?
The discharge on the Whale Spa Deluxe 1 may stop before the basin is empty due to particles in the housing of the discharge pump. These particles can block the pump, causing it to stop. Removing the pump and clearing any debris can resolve the issue.
This answer is automatically generated