Cube Lite60 Manual

Cube Lite60
The Cube Lite60 is an outdoor wireless router with a built-in directional antenna which works in the 60 GHz
spectrum.
This device needs to be upgraded to RouterOS v6.46 or the latest version to ensure compliance with local
authority regulations.
It is the customer's responsibility to follow local country regulations, including operation within legal
frequency channels, output power, cabling requirements, and Dynamic Frequency Selection (DFS)
requirements. All Mikrotik radio devices must be professionally installed.
Note. Information contained here is subject to change. Please visit the product page on
version of this document.

Quickstart

Open the Ethernet door to connect an Ethernet cable to the Ethernet port, connect the other end of the
•
Ethernet cable to the included PoE injector.
Plug the PoE injector into your network switch or computer.
•
Plug the included power supply into the PoE injector to start up the device.
•
Set LAN computer IP configuration to automatic (DHCP).
•
Default IP address of the unit is 192.168.88.1, open this address in your web browser to start the
•
Configuration.
User name: admin and there is no password by default you will be logged in automatically to the Quick Set
•
screen.
We recommend clicking the "Check for updates" button on the right side and updating your RouterOS
•
software to the latest version to ensure the best performance and stability.
To personalize your wireless network, SSID can be changed in the fields "Network Name".
•
Choose your country on the left side of the screen in the field "Country", to apply country regulation
•
settings.
Set up your wireless network password in the field "WiFi Password" the password must be at least eight
•
symbols.
Set up your router password in the bottom field "Password" to the right and repeat it in the field "Confirm
•
Password", it will be used to login next time.
Click on the "Apply Configuration" to save changes.
•
If device RX blocking condition has happened device will restore it's signal after few seconds.
MikroTik mobile app
Use the MikroTik smartphone app to configure your router in the field, or to apply the most basic initial settings for
your MikroTik home access point.
1. Scan QR code and choose your preferred OS.
2. Install and open application.
3. By default, IP address and user name will be already entered.
4. Click Connect to establish a connection to your device through a wireless
network.
5. Choose Quick setup and application will guide you through all basic
configuration settings in a couple of easy steps.
6. Advanced menu is available to fully configure all necessary settings.
See mikrotik.com/products for the latest version of this document.
www.mikrotik.com for the most up to date
Page 1, Document #52350 Modified on: 23.JAN.2020