Advertisement
Narda S3 Radiation Monitor
Product Type NA2270+2271
Please ensure the battery is fully charged before using (charging time can be up to 4 hours).
Note: When the battery display is "RED" there is less than 20% battery life remaining and the
unit should be charged immediately.
When the unit is turned on, please check display and confirm all Self Tests pass during power
up.
IF THE UNIT INDICATES A CLOCK ERROR:
•
First install the software provided with
1
the unit on your PC or Laptop.
•
Use the USB cable provided to connect
2
the unit to your PC or Laptop.
•
Start the NS3-TS and reset clock under
3
the configuration tab.
•
After reset, turn off the unit and wait for
4
at least 5 minutes before switching back
on. If the unit still indicates RTC Error,
then it will need to be returned.
HELP GUIDE
Advertisement
Table of Contents
Summary of Contents for microlease Narda S3 NA2271
- Page 1 HELP GUIDE Narda S3 Radiation Monitor Product Type NA2270+2271 Please ensure the battery is fully charged before using (charging time can be up to 4 hours). Note: When the battery display is “RED” there is less than 20% battery life remaining and the unit should be charged immediately.
- Page 2 Refit the sensor and turn the unit on. If the unit still indicates “Sensor out of Range” then it will need to be returned. CONTACT For further information regarding the above and assistance on this product, please visit go.microlease.com/resources and search for “Narda 2270”. V1.0...
Need help?
Do you have a question about the Narda S3 NA2271 and is the answer not in the manual?
Questions and answers