DEAR EQUIPMENT OWNER, Let us congratulate you on occasion of purchasing your new equipment. It is our firm conviction that you have chosen correctly when deciding on purchasing a GARUDAN-made equipment. Prior to commissioning, a careful studying of and adherence to the Operating Instructions and to the conditions of handling, operation and maintenance is needed since safe, energy-saving, long-lasting, reliable and environment protecting operation of the equipment can be achieved...
The equipment has been designed for smoothing of wrinkles of textiles (ironing after cleaning, products of the textile garment trade, or those of parts, profile pieces prior to assembling) - with aesthetic or technological purposes - by ironing devices, providing an ironing surface of parameters (adequate strength and form, temperature, steam-proof) suiting to the ironing technological requirements.
b) Information relating to commissioning of the equipment Prior to commissioning the equipment, make sure that: • the designed place of erection of the equipment is in compliance with the environmental conditions; • sufficient electric power is available and that the cross section of the conductors and the short protection of the wall outlet socket is sufficient.
Data of connection to the energy supply system ATTENTION! Installation of the equipment, its connection to the electric- resp. steam networks may be performed by a specialist fitter of the given area. Connection of the electric power Voltage, Class of Power consumption Main fuse** Type...
d) Data relating to usage of the machine Description of operation of the equipment: Structural construction: The ironing table consists of three main parts, as follows: baseplate, maschine base with foot switch ventilator house with the fan inside and motor ironing pad, with built-in heating.
Page 7
Control and signal elements: On bottom of the ironing table: - Set-screws for levelling of the equipment. At front of the ironing table: - Foot switch - For the PRAKTIK type, one switch of full width, triggering the suctioning - For the COMPACT types, one upper switch of full width, triggering the vacuuming and the lower switch of full width, triggering the suctioning On top of the ironing table: - Yellow/red main switch;...
• If the reason of the breakdown is not unambiguous, then restarting of the equipment may take place only after a decision taken by the person responsible for the operation, resp. after rectification of the fault by a professional serviceman. •...
Page 9
PRAKTIK I. ironing tables electric circuit diagram with one-phase motor wire connect signal lanp 230V phase wire CS1..3 connector sockets 50Hz „0” wire D1..3 connector plug protect wire ironing pad with built-in K1...K4 switch heating + heat break off foot switch auxiliary pad with fan motor built-in heating...
Page 10
COMPACT. ironing tables electric circuit diagram with three-phase motor Wire connect Signal lamp R, S, T, Phase wire CS1..3 Connector sockets „0” wire D1..3 Connector plug Protect wire ironing pad with built-in Main switch heating + heat break off K1...K4 Switch auxiliary pad with Magnetic switch...
Page 11
Ironing tables list of parts installed ironing pad colour ironing pad cover Maliwatt ironing pad cover installed axle for air divert metal net installed weight air divert with axle ventillator house motor front unit with elektrical part ironong table base clutch for changing blowing to vacuum fork bearing with teflon...
Page 12
heating element for auxiliary pad iron holder auxiliary pad heating switch connector sockets connector sockets connector sockets main switch fixing screw...
Need help?
Do you have a question about the Garudan PRAKTIK and is the answer not in the manual?
Questions and answers