Table of Contents
Advertisement
6
Maintenance
5. Remove all deposits at the cutter blades with isopropyl alcohol and a soft
cloth.
6. Grease the cylindrical areas (4) at both ends of the circular blade (5) with
an All round-High quality Grease. For that hold a greased brush on the
cylindrical areas and turn the axle (3) with a screwdriver for slotted head
screws (slot width 7 mm).
During the turning the areas are all-around greased.
7. If the support was removed during cleaning, adjust the initial state of the
cutter chapter 6.3 .
8. Mount the upper cover sheet (1) with the screws (2) and the support (7)
incl. the lower cover sheet (8) with the screws (6).
15
Advertisement
Table of Contents
