TECOM TS1053 Installation Sheet

TS1053 3G Communication Module
Installation Sheet
Description
The TS1053 3G Communication Module provides a GSM
(wireless) connection to applications such as supported
management software. Refer to (Figure 1 below) for details.
Figure 1: TS1053 module details
1. SMA connector for antenna
2. LED 3 (green) path connection indicator
3. Mounting point
4. LED 1 (red) missing SIM indicator
5. LED 2 (green) radio signal strength indicator
6. Location of connecting pins (under PCB)
7. SIM1 holder (SIM required)
8. SIM2 holder (not supported in the current release)
9. Antenna (with magnetic base)
Refer to "LED indications" on page 2 for LED details.
© 2015 UTC Fire & Security Australia Pty Ltd. All rights reserved.
Installation
The interface module is plugged in to a Challenger Series
control panel PCB's expander slot. Power to the panel must be
off during installation.
Note: A qualified service person, complying with all applicable
codes, should perform all required hardware installation.
In order to configure a TS1053 module, you need to have a
Micro SIM card from your carrier (for example, Telstra) to
provide a data connection via an access point name (APN).
You will need to enter (at least) the APN in "Programming" on
page 2.
Note:
Insert the Micro SIM card into the module only when the
Challenger panel is disconnected from all power sources or
before the module is installed.
To install a Micro SIM:
1. Slide the SIM holder cover to the open position, as shown
in Figure 2 below, item 2.
2. Gently lift the SIM holder cover to expose the SIM holder's
terminals, item 3.
3. Insert Micro SIM with the contacts facing the terminals,
the
item 4.
4. Close the cover and move it to the lock position.
Figure 2: Inserting a Micro SIM
1. SIM holder with cover locked
2. SIM holder with cover unlocked
3. Lift cover to expose terminals
4. Place Micro SIM with contacts down
Note: Avoid touching the SIM holder's terminals or the
Micro SIM's contacts.
1 / 4 P/N MAINST-TS1053 • REV 02 • ISS 07SEP15