Technical Specifications - Smeg WO-20 Manual Use And Maintenance

2.5

TECHNICAL SPECIFICATIONS

TECHNICAL SPECIFICATIONS
Height x Width x Depth (mm)
Weight (kg)
Approved Decibel Level under normal operating conditions (db)
Membranes (nr. 2)
Activated carbon pre-filtration
Tank pre-charge (MPa)
WATER SUPPLY SPECIFICATIONS
Water type
Minimum water temperature (°C)
Maximum water temperature (°C)
Minimum inlet flow rate (l/h)
Maximum inlet pressure (MPa)
Minimun inlet pressure (MPa)**
POWER SUPPLY SPECIFICATIONS
Power supply type
Nominal power (V)
Frequency (Hz)
Absorbed current (A)
Power (W)
Fuse type (electronic board)
PERMEATE WATER SPECIFICATIONS
Output maximum flow rate
Recovery percentage (%)
* The percentage of dissolved salts and other rejected elements is influenced by the quality of
the water, the temperature, the pressure and the totality of dissolved salts and it is different
depending on the types of salts or elements.
** Dynamic: pressure measured in the inlet with the RO system in operation.
The quality of the water produced (permeate) is influenced by the quality of the raw water,
the temperature, the pressure and the totality of dissolved salts.
The treatment of particularly turbid water in presence of organic substances or in suspension
can cause the early clogging of prefilters and / or membranes with and loss of water flow
rate and quality.
The use of the machine outside the limits indicated is considered IMPROPER USE.
7596040 – MANUALE WO-20 EN 21052018 REV.1
WARNING
WARNING
WARNING
WO-20
150x490x550
25
<70
TWG3A1-1100410
Y21408BSG
0.1
Drinkable
5
30
600
0.6
0.15
MONOPHASE + GROUND
230
50
2.4
690
F3.15A
c.a 120
Vedi §3.2
- 8 -