Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Talboys Advanced Series
Summary of Contents for Talboys Advanced Series
- Page 1 INSTRUCTION MANUAL Advanced Hotplates, Stirrers, Hotplate-Stirrers...
-
Page 2: Package Contents
able of onTenTs Package Contents ....Warranty ....Installation ....Maintenance &... -
Page 3: Installation
ConT Upon receiving the Talboys Hotplate/Stirrer/Hotplate-Stirrer, check to ensure that no damage has moist cloth. This will work as well as most scouring pads and is less likely to create deep scratches in occurred in shipment. It is important that any damage that occurred in transport is detected at the time the surface. -
Page 4: Safety Instructions
’ afeTy nsTrUCTions afeTy nsTrUCTions ConT Please read the entire instruction manual before operating the Hotplate/Stirrer/ Earth Ground - Protective Conductor Terminal Hotplate-Stirrer. Alternating Current WARNING! DO NOT use the Hotplate/Stirrer/Hotplate-Stirrer in a hazardous & r Tandards egUlaTions atmosphere or with hazardous materials for which the unit was not designed. Also, the user should be aware that the protection provided by the equipment Troemner, LLC hereby declares under it’s sole responsibility that the construction of may be impaired if used with accessories not provided or recommended by the... -
Page 5: Consignes De Sécurité
’ onsignes de séCUriTé onsignes de séCUriTé ConT Veuillez lire la totalité du manuel d’instruction avant d’utiliser le dispositif Agitateur/ Remplacez la plaque céramique immédiatement si celle-ci est endommagée. Une Agitateur à plaque chauffante. plaque endommagée peut se fendre si elle est utilisée. AVERTISSEMENT! N’UTILISEZ PAS le dispositif Plaque chauffante/Agitateur/ N’UTILISEZ PAS le dispositif s’il y a des signes de dommages électriques ou Agitateur à... - Page 6 6.2lbs (2.8kg) * Below 100°C +/-2°C. Environmental and sample conditions permit- ting. Talboys Advanced 4x4, Ceramic Hotplate-Stirrer NOTE: On all units, the Max. temperature setting on the display is 500°C for a ceramic top and 400°C for an aluminum top.
- Page 7 Controls: see diagram Ship weight: 10.5lbs (4.8kg) Talboys Advanced 7x7, Ceramic Hotplate-Stirrer * Below 100°C +/-2°C. Environmental and sample conditions permit- ting. NOTE: On all units, the Max. temperature setting on the display is 500°C for a ceramic top and 400°C for an aluminum top.
- Page 8 15.9lbs (7.2kg) * Below 100°C +/-2°C. Environmental and sample conditions permit- ting. Talboys Advanced 10x10, Aluminum Hotplate-Stirrer with NOTE: On all units, the Max. temperature setting on the display is 500°C for a optional probe kit and glassware* ceramic top and 400°C for an aluminum top.
- Page 9 Recall last temperature button: Advanced Series Hotplate/Hotplate-Stirrers have a built-in memory that allows users to recall the last set temperature, even after the unit has been turned off. (The temperature in memory is the last temperature that ran for more than 5 minutes.)
- Page 10 yPiCal aTer eMPeraTUre alibraTion roCedUre ingle oinT alibraTion The chart below is an example of an approximate time to boil for the specified amount This method can be used for calibrating the top plate surface. of water in a specific vessel. These values are only approximate and can To set a Single Point Calibration (SPC) adjustment: vary from unit to unit.
- Page 11 ’ eMPeraTUre alibraTion roCedUre Tirring PeraTing nsTrUCTions The micro-processor controlled ramping feature slowly increases speed until the set- as the measured temperature of the top plate. Changes are not saved until point is reached. This feature helps to avoid splashing, improves magnetic coupling and the “SEt”...
- Page 12 Tirrers f the unit gives an error code, immediately switch the unit off. See error table below for proper corrective action. If the error cannot be cleared, please contact your Talboys representative for repairs. Error Cause of Error How to Fix This error cannot be fixed by the end user.
- Page 13 ePlaCeMenT arTs esCriPTion UMber 1. Top plate assembly: 120V, ceramic, Hotplate, Hotplate-Stirrer 886310-00 230V, ceramic, Hotplate, Hotplate-Stirrer 886311-00 120V/230V, ceramic, Stirrer 886312-00 120V, aluminum, Hotplate, Hotplate-Stirrer 886313-00 230V, aluminum, Hotplate, Hotplate-Stirrer 886314-00 120V/230V, aluminum, Stirrer 886315-00 2. Front panel overlay: Stirrer 386217-00 Hotplate...
- Page 14 ePlaCeMenT arTs esCriPTion UMber 1. Top plate assembly: 120V, ceramic, Hotplate, Hotplate-Stirrer 886316-00 230V, ceramic, Hotplate, Hotplate-Stirrer 886317-00 120V/230V, ceramic, Stirrer 886318-00 120V, aluminum, Hotplate, Hotplate-Stirrer 886319-00 230V, aluminum, Hotplate, Hotplate-Stirrer 886320-00 120V/230V, aluminum, Stirrer 886321-00 2. Front panel overlay: Stirrer 386220-00 Hotplate...
- Page 15 10, 120v H oTPlaTe oTPlaTe Tirrer ePlaCeMenT arTs esCriPTion UMber 1. Top plate assembly: 120V, ceramic, Hotplate, Hotplate-Stirrer 886322-00 120V, aluminum, Hotplate, Hotplate-Stirrer 886325-00 2. Front panel overlay: Stirrer 386279-00 Hotplate 386280-00 Hotplate-Stirrer 386281-00 3. Control knobs 286116-00 4. Last temperature (Heating Units only): switch 386100-00 button...
- Page 16 386678-00 Detachable 92” (234cm) power cord: Stirrer 120V 330100-00 Euro Plug 330101-00 Manufactured by: 201 Wolf Drive • PO Box 87 • Thorofare, NJ 08086 • Phone: 1-888-TALBOYS • Fax: 856-686-1601 E-mail: troemner@troemner.com • www.troemner.com 586061-00 (REV 9 - 11/18)
Need help?
Do you have a question about the Advanced Series and is the answer not in the manual?
Questions and answers