Williams Coral Series Operating Manual

Wall mounted cabinets

Advertisement

OPERATING MANUAL for
CORAL WALL MOUNTED CABINETS
This manual covers the Installation, Operation and Routine Maintenance requirements
for the following Williams Refrigeration products:
Coral Wall Mounted Cabinets
Provided the instructions in this Operating Manual are read and implemented correctly,
the optimum performance and reliability of your equipment should be maintained.
The Williams Coral Wall Mounted Cabinet temperature parameters are set as follows:
General Produce (H):
Declaration of Conformity References:
Low Voltage Directive 2006/95/EC
Machinery Directive 2006/42/EC
Electromagnetic Compatibility Directive 2004/108/EC
Pressure Equipment Directive 97/23/EC
Waste Electrical and Electronic Equipment Directive (WEEE) 2002/96/EC
Restriction on Use of Certain Hazardous Substances Directive (RoHS) 2002/95/EC
Refrigerant Designation Global Warming Potential
HFC - R134a
HFC - R404a
Williams Refrigeration declares that all products manufactured by Williams Refrigeration
comply with the above directives as they apply to those products, and those products are
therefore declared to be in conformity with the provisions of the above legislation.
Model No.:
Serial No.:
+1°C(34°F) / +4°C (39°F)
CFC Free Refrigerant
1300
3260

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Coral Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Williams Coral Series

  • Page 1 Provided the instructions in this Operating Manual are read and implemented correctly, the optimum performance and reliability of your equipment should be maintained. The Williams Coral Wall Mounted Cabinet temperature parameters are set as follows: General Produce (H): +1°C(34°F) / +4°C (39°F)
  • Page 2: Installation

    INSTALLATION Removal of Redundant Cabinets Please ensure the old/redundant refrigeration cabinets and refrigeration equipment are disposed of safely and legally. It is recommended that doors are removed prior to disposal in order to ensure safety. Unpacking Remove all external and interior packing and accessories. Ensure all such material is disposed of safely. Selecting a Location for your New Unit The area on which the unit will rest must be level, free of vibration, and suitably strong enough to support the combined weights of the unit plus the maximum product load weight.
  • Page 3: Control Panel

    Carefully lift the unit onto the wall mounting bracket making sure the unit mounting bracket is securely in the wall mount bracket. Assure unit is level. Shimming may be required so unit is tilting at top or bottom. Inspect the glass doors for proper opening and closing motion. Mains Connection The unit comes fitted with a moulded plug for safety and must be earthed.
  • Page 4: Routine Maintenance

    Locating the Controller Grasp the unit cover and pull upwards aways from the unit. (See figure 3). Adjusting the Operating Temperature To adjust the operating temperature press and hold the keys to adjust key for 3 seconds. Use Figure 3 NB: All machines are preset at the factory, however conditions on site will vary compared with test conditions and it may be necessary to perform the above adjustments...
  • Page 5: Condenser Cleaning

    Interior : Cabinet interior should be cleaned regularly with warm soapy water and a soft cloth. Dry thoroughly afterwards and where possible remove all shelving to aid the process. DOOR REMOVAL / INSTALL / ADJUSTMENT Door Removal Locate outside door (sticker in lower corner of door - see figure 4) Open door 3”...
  • Page 6 EVAPORATOR/DRAINLINE Inspect periodically to ensure the drain hole is not blocked. BREAKDOWN In the event of a breakdown, please check thermostat setting and fuse before calling service engineer. When calling, please advise model and serial number. This information can be found on the identification plate inside unit. It should also be noted on the cover of this booklet.
  • Page 7 Williams Refrigeration. Should you require Extended Warranty, state on your order or notify the Dealer or Williams Sales Manager at the time of purchase and they Any repair under warranty will only be carried out in its position of will be able to arrange it for you.
  • Page 8 Sales Tel: +44 1553 817000 Fax: +44 1553 817111 Spares Tel: +44 1553 817017 Fax: +44 1553 817020 Email: info@williams-refrigeration.co.uk Website: www.williams-refrigeration.com WILLIAMS SILVER FROST 30 Route d’Ahun 23150 Lavaveix Les Mines France Tel: +33 5 55 52 27 88 Fax: +33 5 55 62 10 61 Email: cmalabre@williams-silverfrost.com...

This manual is also suitable for:

Coral cwm18Coral cwm14

Table of Contents