Advertisement
GENERAL SAFETY INSTRUCTIONS CONT.
WARNING! Ensure the heater is at least 200cm from any object.
DO NOT leave unattended.
When not in use, store the heater carefully in a safe, dry, childproof location.
2. INTRODUCTION & SPECIFICATION
Powder coated metal construction with two ceramic heating elements
providing instant heat when required. Ideal for workshop, garages etc.
Features chemically polished reflectors to provide maximum heat
emission. Controllable power output with rocker switches on the side of
the unit. Fitted with sturdy frame and carry handle. Supplied with cable
and BS1363 approved plug.
max. Power:
min. Power:
Input supply:
Dimensions (W x D x H):
Heater Identification Fig.1
1) Heater Element
2) Safety Guard
3) Heater Body
4) Handle
3.
CERAMIC ELEMENTS
DO NOT touch an element just after switching 'off' power supply. Allow to cool.
Ensure that the heating elements are:
• Free of fractures and cracks and good general condition.
• Maximum of 1.4kW
WARNING! There are no user serviceable components inside this heater, if an element requires replacing please return to an authorised
Sealey dealer.
4. OPERATION
WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before using the heater.
NOTE! The ceramic element is fragile and therefore it is important that it is not subjected to any unnecessary shocks or vibration and is not
moved when it is on or until cooled down.
ImPORTAnT: DURInG RElOCATIOn, THE HEATER SHOUlD REmAIn SWITCHED OFF AnD DISCOnnECTED FROm THE POWER
SUPPlY.
In the event of the heater being knocked over, a safety cut-out switch, which activates at an angle of 35º (±10º), will disable the heater.
Follow these steps to re-start the heater.
a)
Switch 'off' the heater at the on/off switches. As Fig.2.
b)
Disconnect the power cord from the power supply.
c)
Return the heater to a standing position.
d)
If no damage has occurred to elements, replace safety guard if applicable, re-connect power cord to the power supply and switch the
heater back on.
Should the power cord require replacement, a complete wiring loom should be purchased and fitted by a suitably qualified person.
4.1
Ensure the heater is at least 200cm from any object.
4.2
Plug in the heater and switch it on.
4.3
The heater has the following settings: See Fig.2.
Position 0:0
Off position.
Position I:0
Upper element only.
Position 0:I
lower element only.
Position I:I
Both elements.
4.4
make sure the heater plug is disconnected from the mains supply before any cleaning is attempted.
Also allow the heater to cool completely. Do not use water or other liquids, or harsh abrasive cleaners to
clean the heater.
4.5
Clean the exterior with a soft damp cloth with some mild detergent.
4.6
When the heater is no longer required, switch off and unplug the unit.
4.7
To replace any of the element, contact your authorised Sealey dealer.
2800W
1400W
230V 13A
360 x 370 x 555mm
5) Power on neon
6) Power On/Off
7) Stand
Original Language Version
Fig.1
Fig.2
CH2800
Issue: 1 - 21/05/10
On
Off
On
Off
Advertisement
