Advertisement
NOTE: Ensure the safety handle is to the right and the lock plate assembly (10) is locked in a corresponding pair of safety latches (26) to
prevent accidental lowering.
6.2.7. When work is completed, remove all tools from underneath the lift before lowering.
6.2.8. Move the safety handle to the left hand side (in the depression) and lower the lift by slowly depressing the release foot pedal to gently lower the
motorcycle. Move the safety handle back to the right hand side ready for the next lifting operation.
NOTE: Lower the motorcycle slowly, in a controlled fashion. Never allow the motorcycle to lower rapidly.
6.2.9. When the lift is fully lowered, unsecure the motorcycle and remove it from the lift.
7.
MAINTENANCE
7.1.
Clean and lubricate on a regular basis.
7.2.
Regularly check oil level via filler hole. With piston fully down remove filler plug, oil should be level with bottom of filler hole. Top-up as
necessary. Use a good quality jack oil such as Sealey Hydraulic Jack Oil. Do not use brake fluid.
Ensure no dirt enters hydraulic system when filling or removing/replacing components.
7.3.
Lubricate the air motor with a good quality jack oil such as Sealey Hydraulic Jack Oil, once or twice a month. Add the oil through the air valve
whilst holding down the lever.
7.4.
Always dispose of waste oil according to local authority guidelines. If in doubt consult your local authority.
7.5.
Keep the lift clean and wipe off any oil or grease. Lubricate all moving parts.
7.6.
Before each use check all parts. If any part of the lift is damaged or suspect, remove the lift from service and take necessary action to repair.
8.
TROUBLESHOOTING
Lift will not lift load.
Lift will not hold load.
Lift will not lift smoothly
or to full height.
Lift will not lower completely.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
fig.4
1. Release valve not fully closed.
2. Oil level low.
3. Air supply low.
1. Release valve not fully closed.
1. Oil level low.
2. Air in hydraulic system.
1. Release valve not sufficiently open. 1. Slowly open valve further.
www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500.
Environmental Protection
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
1. Close valve firmly.
2. Top-up to correct level.
3. Min. requirement 120psi.
1. Close valve firmly.
1. Top-up to correct level.
2. Bleed system.
01284 757500
01284 703534
fig.5
www.sealey.co.uk
sales@sealey.co.uk
MC680A
Issue: 1 - 22/09/14
Advertisement
