3M Scotch-Weld AE II LT Quick Start Manual

Scotch-Weld
Applicator AE II LT
Important
Safety Instructions
Intended Use
The 3M Scotch-Weld Hot Melt Applicator AE II LT is
designed for use with 3M™ Scotch-Weld™ Hot Melt
LM AE Adhesive Sticks in an industrial environment.
Using the applicator with any other adhesive or for any
purpose other than for which it is intended is not rec-
ommended and could cause unsafe conditions.
FOR INDUSTRIAL OR PROFESSIONAL USE ONLY
Scotch-Weld Hot Melt Applicator AE II LT
operation and maintenance.
WARNING
To reduce the risk of electrical shock or injury while
operating or servicing the Scotch-Weld Hot Melt Applicator
AE II, observe the following safety rules:
1. Operate the applicator only as described in this manual.
2. Use only 3-pronged grounded plug and properly grounded
outlet. Failure to use properly grounded plug and outlet
may cause electrical shock. If you are not sure of proper
connections, get help from a qualified electrician or
service person.
3. Do not unplug the applicator by pulling on the cord.
Grasp the plug, not the cord, to unplug.
4. Do not handle the plug or applicator with wet hands.
5. Do not use the applicator outdoors or on wet surfaces.
6. Do not use the applicator with a damaged cord or plug.
7. Do not use the applicator if it is not working properly or has
been dropped, damaged, submerged in water or left outdoors.
8. Do not use an unapproved extension cord with the applicator.
Use of an unapproved extension cord may cause electrical
shock. Use an extension cord that complies with NEC
requirements and state and local codes and
other requirements.
9. Do not attempt to service this applicator. It is not
designed for servicing and attempting to do so may cause
electrical shock.
Hot Melt
™
1. Do not touch hot adhesive, applicator tip or metal
components. May cause burns. Wear heat resistant gloves
and safety glasses.
2. Do not pull adhesive cartridge from the rear of the
applicator while in operation. Removing adhesive from
the rear may cause molten adhesive to flow out the rear
of the applicator which may cause burns and damage
the applicator.
Use only 3M Scotch-Weld Hot Melt LM AE Adhesive Sticks.
Note: For health and safety information, see product label
and Material Safety Data Sheet for 3M Scotch-Weld Hot Melt
adhesives before using.
Set up and
Installation Procedures
Remove
bench stand from shipper and inspect for obvious damage.
FOR INDUSTRIAL OR PROFESSIONAL USE ONLY
• Save these instructions
• Read all instructions before using this product
1. Attach one or both of the supplied bench stands.
The small stand snaps into the two holes located on the
front of the applicator housing.
The large wire platform stand slides into the base.
ALWAYS USE A BENCH STAND WITH
YOUR APPLICATOR.
Caution
Indicates
high voltage
3M Scotch-Weld Hot Melt Applicator AE II and
Indicates
hot surface