Sealey AB2158.V3 Instructions Manual page 5

7. FUSE
7.1. Fuse Replacement
NOTE: This is a fuse protected heater.
If your heater fails to ignite check the fuse as shown in fig.14 before contacting your local service agent.
WARNING! Unplug the heater from the mains power supply before attempting any maintenance work.

7.1.1 Remove the control panel screws using a medium cross head screwdriver and lift off the side panel to reveal the printed circuit board.
7.1.2 Disconnect switch wires from the power switch.
7.1.3 Remove fuse from holder as shown.
7.1.4 Replace fuse with one of the same specification.
WARNING! DO NOT substitute the fuse with one of a higher or lower current rating as this may result in a fire hazard.

7.1.5 Reconnect switch wires to the power switch.
7.1.6 Replace the side panel.
fig.14
© Jack Sealey Limited
fig.10
fig.12
Original Language Version
fig.13
AB2158.V3 Issue:3 (1,4,5,6) - 13/07/18
fig.11