Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cornell CSI-E220SRD
Summary of Contents for Cornell CSI-E220SRD
- Page 1 Steam Iron CSI-E220SRD...
-
Page 2: Safety Regulation
SAFETY REGULATION 1) Always switch off and unplug the power socket from the main electrical supply BEFORE cleaning and also when the appliance is not in use. 2) NEVER IMMERSE THE APPLIANCE, POWER CORD OR PLUG INTO WATER OR OTHER LIQUIDS. Please refer to the section on “Care and Cleaning”. -
Page 3: Parts Identification
10) This appliance is not intended for use by people who are physically and mentally impaired (including children), or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. PARTS IDENTIFICATION Cord Spray Nozzle... -
Page 4: Specification
SPECIFICATION Model CSI-E220SRD Voltage 220-240V~ Frequency 50/60Hz Power 2200W OPERATING INSTRUCTIONS Note: For the first use, it is normal to see a little water retention in the water tank due to production test. 1. Remove any sticker or protective foil from the soleplate. - Page 5 Temperature Fabric Ironing methods control Iron the reversed side first. Synthetic, Do not use the spray function Fibres, · as spraying could cause Nylon stains. Iron on the reversed side to Silk, Wool ·· prevent shiny spots. Set the steam control to “ ”...
- Page 6 4. Correct ironing temperature is achieved when the pilot light turns off. 5. The pilot light will turn on from time to time during ironing. 6. Set the steam control to “ ” position, then start ironing after releasing steam for several seconds. 7.
-
Page 7: Troubleshooting Guide
TROUBLESHOOTING GUIDE Problem Possible causes Solution Check the plug and Connection problem. mains. Soleplate Set the temperature does not The temperature dial dial to the correct heat up is in “Min” position. temperature for your fabric. The temperature Set the temperature Temperature control dial is not in control dial to the... - Page 8 The iron is not hot Wait until the pilot light enough. goes off before ironing. Water is over the Discard some water. “Max” position. Fill in water to the Inadequate water. correct level. Clean (set the Too little temperature dial to Blockage in the water steam tank or soleplate...
-
Page 9: Care And Cleaning
CARE AND CLEANING 1. CAUTION: Ironing over zippers/rivets on jeans etc. may cause scratches on the soleplate. 2. Turn the temperature knob to “min” and unplug the power. Place the iron upright and let the iron cool completely before cleaning and storing. 3.
Need help?
Do you have a question about the CSI-E220SRD and is the answer not in the manual?
Questions and answers