Advertisement
5. MAINTENANCE
5.1.
When the lift is not in use, it must be returned to its lowest position to minimise ram and piston corrosion.
5.2.
Keep the lift clean and wipe off any oil or grease. lubricate all moving parts..
5.3.
Before each use check all parts. If any part of the lift is damaged or suspect, remove lift from service and take necessary action to
repair.
DO NOT use the lift if it is believed to have been subjected to abnormal load or shock. Inspect and take appropriate action.
5.4.
check the ram and piston periodically for signs of corrosion. clean exposed areas with a clean oiled cloth.
5.5
Topping up the oil. Top up the oil as in section 3.6.1. above. Use only a good quality jack oil, such as Sealey Jack Oil.
DO NOT use any other fluid such as: brake fluid, automatic transmission fluid or engine oil.
6. TROUBLESHOOTING
SYMPTOM
POSSIBLE CAUSE
Jack will not lift
release valve not
load.
tightly closed.
overload condition.
Hydraulic unit
malfunction
Jack will lift
release valve not
but not retain
tightly closed.
pressure
overload condition.
Hydraulic unit
malfunction
Jack will lift
Reservoir overfilled
not lower after
unloading
linkages binding
Poor lift
fluid level low
performance
Air trapped in system
Poor lift
fluid level low
performance
Air trapped in system
Will not lift to
fluid level low
full extension
IMPORTANT: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THE LIFT.
Hydraulic products are repaired by local service agents only. We have service/repair agents in all parts of the uK.
DO NOT return the product to us. Please call us on 01284 757500 to obtain the address and telephone number of your local agent.
If the product is under guarantee please contact your dealer.
De-commissioning: should the lift become completely unserviceable, draw off the oil into an approved container and dispose of the lift and
the oil according to local regulations.
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycle
centre and disposed of in a manner which is compatible with the environment.
Parts support is available for this product. to obtain a parts listing and/or a diagram please log on to: www.sealey.co.uk,
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
SOLUTION
close release valve fully.
remove/reduce load
service hydraulic unit
close release valve fully.
remove/reduce load
service hydraulic unit
Drain fluid to correct
level
clean & lubricate
moving parts
Ensure proper fluid level
Bleed system
top up to correct level
Bleed system
Ensure proper fluid level
Environmental Protection.
email: sales@sealey.co.uk or phone: 01284 757500
Advertisement
