Visual Inspection - Harken Industrial CMC CLUTCH Inspection Procedure

Inspection Procedure
CMC CLUTCH™ by Harken Industrial™

1. Visual Inspection

Ensure the presence and legibility of the device markings.

Ensure that the product number is located and is legible on the backside of the Chassis in the area covered
by the Control Handle when it is in the Stop position.

Ensure that the CE certification mark is located and is legible on the inside surface of the Moving Side Plate.

Visually compare the device with a new device and check to make sure that there are no missing or modified
parts.

Carefully inspect the entire device for signs of damage such as dents, deep scratches, cracks, yielding or
excessive wear. Check for any sharp edges, especially in the areas of the rope path. Take extra care to
inspect attachment points such as the Attachment Eye and the Becket for signs of damage or deformation.

Inspect the Sheave, Tension Rope Guide, and Friction Shoe for wear. The Tension Rope Guide and Friction
Shoe are shown in blue and the Sheave wear indicators (3) are shown in orange in the images below.
2