Summary of Contents for Identiv 8210 uTrust TS
- Page 1 User manual for uTrust TS KEYPAD Physical Access Control Readers Version 1.4 8210 Confidential Author Sixtus Stanly Version Date 25-Apr-2018 Document no 821004...
- Page 2 Document History Version Date Description of Change Author 03-June-15 Initial version Suresh Kumar T 12-Oct-15 Wiegand section, temp profile, Suresh Kumar T outdoor section modified. 26-Oct-15 Document modified as per inputs Sudhan from UL Immanuel G 25-Apr-18 Updated comments from UL wrt Sixtus Stanly to UL1076...
-
Page 3: Table Of Contents
uTrust TS KEYPAD User Manual Contents Introduction ..........................4 Reader ............................4 Functionality ..........................4 Front/Top Casing ........................4 Back View/plate ........................5 Product details ........................... 6 Specifications ..........................6 Label ............................6 Installation details ........................7 Parts List ........................... 7 Recommended Infrastructure .................... -
Page 4: Introduction
uTrust TS KEYPAD User Manual 1.0 Introduction This document details the Physical Access Control Reader uTrust TS KEYPAD and its basic user instruction and installation procedures. 2.0 Reader Functionality TS KEYPAD reader is a physical access control smart card reader that can read HF and LF contactless credentials, conforming to the following standards: ISO 14443 A &... -
Page 5: Back View/Plate
uTrust TS KEYPAD User Manual Back View/plate Standard version Back plate Page 5 of 12... -
Page 6: Product Details
uTrust TS KEYPAD User Manual 3.0 Product details Model Name : uTrust TS keypad Device Type : RFID reader, 13.56MHz (HF) / 125 KHz (LF), keypad Physical Access control Reader (accessory equipment) Type of equipment : Potted Reader, Suitable for Indoor use Interface Type : Phoenix connectors Voltage Rating... -
Page 7: Installation Details
uTrust TS KEYPAD User Manual During wiring, make sure that the +VDC lines does not make contact with any other cables, as it might affect reader functionality/ cause damage to the reader. 6.0 Installation details Wiring methods shall be in accordance with the National Electrical Code (ANSI/NFPA70), local codes, and the authorities having jurisdiction. -
Page 8: Mounting The Reader
uTrust TS KEYPAD User Manual Shield Ground/ Drain – Black color should be connected to the cable shield. Caution: During wiring, make sure that the +VDC lines does not make contact with any other cables, as it might affect reader functionality/ cause damage to the reader. 6.4 Mounting the Reader 6.4.1 Location of mounting holes on wall... -
Page 9: Reader Installation Steps
uTrust TS KEYPAD User Manual Phoenix connector Reader – 4 Holes and 1 Slot 6.4.2 Reader Installation Steps a. Make holes on the wall as per the image above. b. Insert the nylon screw plugs into the wall. c. Connect the wires as per the Table 2 or Table 3. d. - Page 10 uTrust TS KEYPAD User Manual Page 10 of 12...
-
Page 11: Power Up And Testing
uTrust TS KEYPAD User Manual Power up and Testing Turn power on The LED blinks 3 times green with a long beep, then turns red Present a card The LED blinks green, and a short Beep is emitted Press Key Buzzer tone &... -
Page 12: Certifications
Communication via Wiegand was evaluated by UL and serves as the interface between the reader and panel • When the reader is powered by a supply other than Identiv Mx series controller, the power supply should be a UL 294 and 1076 listed , class 2 supply. •...