NORBERTS GF-864 Assembly/Installation Instructions

ASSEMBLY/INSTALLATION INSTRUCTIONS
READ THIS DOCUMENT AND ALL OTHER ACCOMPANYING PRODUCT DOCUMENTATION THOROUGHLY
BEFORE INSTALLING, USING OR PERMITTING USE OF THIS EQUIPMENT. REQUIRE ALL PERSONS
INTENDING TO USE THIS EQUIPMENT, AS WELL AS THOSE INSTRUCTING OR COACHING USERS,
ASSISTING USERS AND/OR SPOTTING USERS TO READ THIS DOCUMENT THOROUGHLY BEFORE YOU
AUTHORIZE EQUIPMENT TO BE UTILIZED FOR ANY PURPOSE.
This portable beginning gymnastics bar is not designed for kips or big swings.
Use this bar only for pull ups, pull overs and other strength development exercises. Only a qualified instructor can make
recommendations regarding the exercises this equipment can handle based on user skill, weight and other factors.
BEFORE YOU BEGIN, PLEASE READ THESE IMPORTANT REMINDERS!
A 4X8 panel mat or mini bar mat MUST be used with product to stabilize the bar and provide cushioning.
•
The area where you will use the bar MUST be flat, level and free of any obstructions.
•
Small scratches can be repaired with grey spray paint or model paint.
•
This bar is meant for indoor use; it can be used outside, but should never be left out overnight.
•
As with all gym equipment, all use MUST be properly supervised.
•
NEVER use the bar without first checking for loose fittings or damage.
•
Only experienced professional coaches are qualified to assess weight load limitations of this product by factoring
•
in complex variables as user size/type of activity to which it will be subjected. Supplied rails did not fail when
subjected to static weight load of 100 lbs.
FAMILIARIZE YOURSELF WITH ALL SUPPLIED COMPONENTS.
YOU SHOULD HAVE RECEIVED THE FOLLOWING:
A. Rail W/Pistons Attached (1 Set)
B. T-Leg Uprights (Two Each) W/Factory-Installed Clamping Pull
Pins
C. Base Plate Spreader Bar (1 Each)
D. Pouch With Allen Wrench and Instruction Sheet
STEP 1.
Lay base plate spreader bar on a smooth even surface and install T-
legs by sliding them over the two shafts on base plate.
IMPORTANT:
T-leg struts MUST be facing outwards as pictured.
•
Allen nut MUST be on outside of T-leg.
•
Use Allen wrench (provided) to tighten T-leg to the Base Plate.
DO NOT OVER TIGHTEN ALLEN NUT!
IMPORTANT CONSUMER PRODUCT HAZARD WARNING INFORMATION--PLEASE READ!
GF-864 MINI BAR (PAGE 1 of 2)
IMPORTANT BAR LIMITATIONS!
REV 1/18/15