Advertisement
DO NOT modify speed control or attempt to fit any additional external speed control device to the fan.
When not in use place the fan in its original box, or otherwise cover, to protect from dust and store in a safe, dry, childproof
location.
NOTE: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities
or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
2. INTRODUCTION
High velocity fan suitable for movement of huge volumes of air. Features three-speed
settings for choice of airflow and tilting blade cradle. Fully guarded blades with large
diameter base for safety and added stability. Mains cable storage keeps it tidy when not in
use. Suitable for industrial, commercial, agricultural, workshop and showroom applications.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HVF20
Fan Diameter:. . . . . . . . . . . . . . . . . . . . . . . . . 550mm(20")
Speeds: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Speed Range: . . . . . . . . . . . . . . . . . . 1100/1225/1350rpm
Maximum Airflow: . . . . . . . . . . . . . . 110mtr³/min (3900cfm)
Motor Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110W
Supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230V
Current:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5A
4. ASSEMBLY
4.1.
Assemble the stand by inserting the short tubes on each side of the fan into the
stand tubes. Ensure the buttons pop up through the holes to lock them into place.
(See fig.1).
5. OPERATION
WARNING! Ensure that you read, understand and apply safety instructions in Section 1 before using fan.
5.1.
Check that the speed control is set to "0" (off) and then plug into the mains power supply and switch the power on.
5.2.
The fan features 3 speeds which are selectable using the switch located at the back of the fan above the motor.
1 or 2 settings will suit most needs, 3 is used for maximum air movement.
5.3.
Adjust the direction of the air flow by moving the base from side to side and tilting the fan up or down.
5.4.
When the fan is no longer required, ensure you turn the speed control switch to "0" (off) and disconnect the fan from the mains
power.
fig.1
6. CARE
IMPORTANT: Turn the control switch to OFF and disconnect the fan from the power supply before cleaning.
6.1.
Use only a soft, damp cloth to clean the fan.
6.2.
DO NOT submerse the fan in water and NEVER allow water to drip into the motor housing.
6.3.
DO NOT use solvents or other chemicals to clean the fan.
6.4.
To clean the fan blades, loosen the 7 clips around the guards and then lift off the front guard from the top hook.
6.5.
Wipe the blades and guards.
6.6.
Reassemble by hooking the front guard into place at the top of the rear guard and then push the 7 clips back into place so that they
engage both the front and rear guards.
© Jack Sealey Limited
Original Language Version
fig.2
HVF20 Issue: 1- 10/12/14
Advertisement
