M.D. Resource K Pump Instructions For Use Manual

Hide thumbs

Table Of Contents

K P

UMP

Instructions for Use

198-003 K Pump IFU Rev D

Table of Contents

Summary of Contents for M.D. Resource K Pump

Page 1 Instructions for Use 198-003 K Pump IFU Rev D...
Page 2: Table Of Contents
Overview & Intended Use ................. 5 Warning and Safety Information ............... 6 Chapter 1: Getting Started ................. 7 Chapter 2: Identifying the K Pump ..............9 Chapter 3: Accessories ..................10 Chapter 4: Connecting Accessories / Devices ..........10 Chapter 5: Activating the K Pump ..............12 Chapter 6: Cleaning the K Pump ..............
Page 3: Symbols
Relative Humidity Limitation for operating Operating environment (on Device environment (on Device label) label) Relative Humidity for Transport and Atmospheric Pressure limit for Storage environment (on Box label) Transport and Storage environment (on Box label) Keep Dry 198-003 K Pump IFU Rev D...
Page 4: Introduction, Disclaimer And Contact Information
Introduction, Disclaimer and Contact Information Introduction  Thank you for choosing the M.D. Resource K Pump. The K Pump is a peristaltic pump using three rollers to create pumping action. This manual provides instruction for operation, maintenance, and troubleshooting procedures for the K Pump. Users should be trained in its use and applicable medical procedures.
Page 5: Overview & Intended Use
 This K Pump Instruction for Use provides information about using the K Pump infiltrator, set-up, performing cleaning / troubleshooting, and obtaining support. Product’s Intended Use  The K Pump is designed to infiltrate tumescent fluid into a patient during cosmetic or plastic surgery procedures. Electronic Accessories and Equipment ...
Page 6: Warning And Safety Information
Do not exceed the limits of 0 to 10 on the flow control, overturning may cause damage to the speed control. Safety Guidelines  The K Pump is designed to ensure both the highest level of product quality and safety for the user. To maintain both quality and safety, follow the guidelines and instructions in this document.
Page 7: Chapter 1: Getting Started
Inspect the K Pump for physical damage while unpacking. Contact M.D. Resource immediately if any physical damage is observed. If the K Pump is for evaluation, keep the shipping box. These are needed to return the unit.  Removing the Product from the Shipping Box Remove the styrofoam placed on top of the box.
Page 8 Prior to the delivery of ﬂuids:  Attach transformer to power cord and plug this assembly and footswitch into back of K Pump. If used in conjunction with a TMD, attach the umbilical from the K Pump to the TMD.
Page 9: Chapter 2: Identifying The K Pump
Chapter 2: Identifying the K Pump This chapter contains information about identifying K Pump features and the accessories required to configure your device for use.  K Pump Features The following two illustrations are designed to help you to become familiar with the...
Page 10: Chapter 3: Accessories
 Optional Device’s Used in Conjunction Tumescent Measuring Device LS2 Liposuction Aspirator To place an order for the accessories or the devices listed above, contact M.D. Resource. at 510.732.9950 or call toll free 800.633.8423. (Refer to Appendix B for further listings of parts & accessories) Chapter 4: Connecting Accessories / Devices This chapter contains information about properly routing accessories on your K Pump.
Page 11 Lastly, take the “Foot Pedal” and insert the tubing end into the bulkhead connectors (See pictorial representation, Page 8 – Bulkhead Connector). Note: For safety, only use the specified parts supplied by M.D. Resource. (Refer to Page 16 for Technical Specifications and Page 17 for Parts & Accessories).
Page 12: Chapter 5: Activating The K Pump
Note: For safety, only use the specified parts supplied by M.D. Resource. (Refer to Page 16 for Technical Specifications and Page 17 for Parts & Accessories). Note: The K Pump uses a power adaptor to isolate itself from the mains. For safe operation, only use genuine parts supplied by M.D. Resource.
Page 13: Chapter 6: Cleaning The K Pump
This chapter provides information regarding the proper cleaning of your K Pump.  Cleaning the External Case When cleaning your K Pump, turn off the main power switch and then disconnect from the power source. Wipe down all external surface area with a cloth: ...
Page 14: Chapter 7: Support & Warranty Information
This chapter provides information regarding obtaining support, if necessary, from M.D. Resource.  Support Should your K Pump require repair, contact M.D. Resource. to obtain an RMA (Return Merchandise Authorization) to return the unit to M.D. Resource. for servicing to maintain the product’s warranty.
Page 15: Chapter 8: Troubleshooting
Chapter 8: Troubleshooting This chapter contains information about troubleshooting your K Pump.  The following table describes some of the most common troubleshooting options for the K Pump: Topic Possible Cause Possible Solution Power Switch not “ON”. Turn Power Switch “ON”...
Page 16: Appendix A: Technical Specifications
10% to 90% (non-condensing)  Atmospheric Pressure: 98 kPa - 105 kPa  Weight Limits & Maximum Dimensions 6 1/2” (L); 9 1/2” (W); 7 1/2” (H) max Dimensions Weight Approximately 5.0 lbs (without accessories) 198-003 K Pump IFU Rev D...
Page 17: Appendix B: Parts & Accessories
115-003 Model # GTM21097-5024 For Replacement Parts, please contact M.D. Resource. to service or repair these parts. Do not attempt to service or repair these items. Refer to Page 7 - Support & Warranty to follow instructions on how to return the unit to M.D. Resource.
Page 18: Appendix C: Emc & Other Interference
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions The K Pump is intended for use in the electromagnetic environment specified below. The customer or the user of the K Pump should assure that it is used in such an environment. Emission test...
Page 19 The K Pump is intended for use in the electromagnetic environment specified below. The customer or the user of the K Pump should assure that it is used in such an environment. Use of accessories, transducers, power cords, and cables other than those sold by Medical Device Resource Company may result in system failure, increased EMC emissions, and/or decreased EMC immunity of the K Pump.
Page 20 To assess the electromagnetic environment due to fixed RF transmitters, and electromagnetic site survey should be considered. If the measured field strength in the location in which the K Pump is used exceeds the applicable RF compliance level above, the K Pump should be observed to verify normal operation.
Page 21 Recommended separation distances between portable and mobile RF communications equipment and the K Pump. The K Pump is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer r user of the K Pump can help prevent...