Pannier Exhibit Base Assembly And Installation Instructions

Pannier Exhibit Base

Assembly and Installation

Instructions
Installing a Pannier exhibit base is as easy as 1, 2, 3.
Step 1 – Inspect and Organize
As soon as your shipment arrives inspect all pieces
and assembly components to make sure your delivery
is complete.
For each exhibit base, the following will be
included: (Figure 1)
A. Frame Leg(s)
B. Top Angle Bracket
C. Exhibit Panel (Use Pannier embedded
fiberglass panels for best results)
D. 1/4" Aluminum Drive Rivets or
1/4"-20 Machine Screw
E. 3/8" Aluminum Drive Rivets
F. Frame Assembly
Assembling and installing a Pannier Exhibit Base is a
straight forward process made even easier if two or
more people work together using the proper tools and
materials to complete the task.
Recommended tools and materials:
• Power or manual post-hole digger
• Shovel
• Wood braces
• Hammer
• Clamps
• Nails
• Plastic sheeting
• Cement
• Gravel
• Tamping bar
• Level
Pin
Head
Drive Rivets
Phillips Head
Machine Head
Screw
Figure 2
Page 1 of 2
(D) 1/4" Drive Rivets/
1/4"-20 Machine Head Screws
(D) / " Drive Rivets
3
8
(A) Frame Legs
Upright
Figure 1
For use with
the following
exhibit bases:
Upright/Cluster
Step 2 – Assembly
If you purchased your exhibit panels and bases from
Pannier, most of the assembly has already been
completed for you.
All you need to do is attach the exhibit pedestal base(s) to the
completed panel frame assembly with the supplied buttonhead
screws as shown in Figure 1. Proceed to Step 3 – Installation.
If you purchased the exhibit bases only, you will need
to install your exhibit panel and attach the pedestal
base(s).
To install the exhibit panel, first remove screws from the top
angle. Place the frame assembly face-up on a raised sturdy
work surface. Slide your exhibit panel face-up into the frame
assembly channel, making sure the panel bottom matches the
frame bottom as indicated by weep holes. Attach the Top Angle
Bracket with supplied 1/4" drive rivets to securely enclose the
exhibit panel. Insert the rivet, and drive the pin (see Figure 2)
down with a hammer until flush with the head. If your exhibit
base came with screws, attach the Top Angle Bracket with
supplied 1/4"-20 screws to securely enclose the exhibit panel.
Insert screws and screw into holes (see Figure 2) with a phillips
head screw driver until inserted all the way.
Attach the completed frame assembly to the leg(s) with the 6
supplied 3/8" drive rivets. Proceed to Step 3 – Installation.
(B) Top Angle
Bracket
(C) Exhibit Panel
(F) Frame Assembly
Triangular Kiosk
Figure 1
Triangular Bulletin
Kiosk Case
Upright Cluster
Figure 1