Unique Lightscaping Apollo 3' lead 12v Assembly/Installation Instructions

Model:
(91062-147) Apollo 3' lead 12v
(91065-147) Apollo 3' lead GS 12v
(91058-147) Apollo 12v
(91061-147) Apollo 12v GS
(91069-147) Apollo 24v
(91072-147) Apollo 24v GS
Description: 12V or 24V Terra Therma Composite & Brass In-Ground Well Light
Lamp Provided: PAR 36 35 Watt Lamp
ASSEMBLY / INSTALLATION INSTRUCTIONS:
Please read carefully before installing. Save these instructions.

TOOLS REQUIRED

It is recommended that when installing any low voltage fixture that you have (at a minimum) the following items: voltage meter, amp probe, wire nuts,
and assorted hand tools
1. Determine fixture location. Dig a 5" hole and bury the fixture. The proper depth should leave the upper edge of fixture ¾" or more above
ground. This will prevent excessive moisture from building up in the fixture. In addition, you should dig the hole deep enough to allow for at
least 6" of gravel. This will help dissipate water away from the fixture.
2. Coil 1 ½ -2 feet of excess wire at the fixture so as to be able to pull the lamp out of the fixture for future maintenance and re-lamping.
3. Simply pull the 25' wire lead to your connection point (Hub). Separate the two wires and connect one each to the provided Hub connectors.
Even though polarity is not an issue, it is recommended that you always match the polarity, that is to say put the lettering-to-lettering wires
and the ribbed to ribbed wires together. While not necessary we do recommend that you bury all additional wire at the fixture, rather than
cutting off the excess. This helps maintain flexibility and even voltage.
IMPORTANT LENS OPTIONS: To get the maximum benefit of your fixture and to provide your customer with the ultimate state of the art lighting
portrait we have provided the below described lenses. These are intended to allow you to provide the desired level of light, as well as reduce the
effects of glare.
1) HEX ALUM.BAFFLE: Use to reduce glare.
2) CLEAR LENS: Use for maximum light output.
3) DE-OP (FROSTED) LENS: Use to reduce lamp output and soften an object.
4) AX-OP (LINEAR) SPREAD LENS: Use to spread out light for broader coverage.
5) VI-OP (DIMPLED) LENS: Use to diffuse and reduce sty ration rings.
APOLLO: To attach any of the extra lenses, remove the top brass ring and insert the additional desired lens. Replace the brass ring and
•
lens to the composite can and rotate brass ring until pem nuts drop into composite can reliefs.

Important safety and maintenance instructions

1. Use with low-voltage outdoor lighting system only.
2. Lamp is hot when lit! Do not touch when lamp is on!
3. Allow fixture to cool before touching or re-lamping fixture!
4. Keep away from materials, structures or landscapes that may burn! I.E. mulch, leaves, bark, etc.
5. Do not submerse fixture in water.
6. Clean fixture with mild soap. Do not use acid or any other solvent base cleaner.
CAUTION: DO NOT OVERLOAD CABLE or TRANSFORMER and maintain polarity at all times.
between 10.8 and 12 operating volts. For 24 volt systems, keep each fixture between 21.6 and 24.7 operating volts.
qualified electrical contractor and local electrical codes before installing any electrical product.
For 12 volt systems, keep each fixture
Consult with a