Bigblu Tooway Surf Beam 2+ Quick Start Manual

Bigblu SB2 Installation / Dish pointing:

To install the modem and check Signal
levels, connect your computer directly
to the bigblu modem or connect your
wireless device to the external Wi-Fi
router and open a web browser and
navigate to:
http://192.168.100.1/install
On this page you will then be
prompted to select the beam colour
for your location, which can be found
https://finder.tooway-
instal.com/fixe/pages/index.html
Once the correct beam color is
selected then click the right (Next)
arrow.
This will activate the dish pointing
process where the transceiver on the
dish will to start making a *beeping*
Sound and you will physically need to
adjust the dish by elevation and
direction.
When you are close to locking on to
the signal the Beeps will become
quicker until will make the dish to
start making a continuous (Solid
Tone). The Current Rx SNR readings
on the modem needs to be at least
10dB or higher this will indicate that
the dish is in full alignment.
When the SNR signal is 10dB or above click Finish.