Advertisement
Table of Contents
2/28/2019
How to configure Snom PA1 for 3CX
This guide applies to v15.5 only.
On this topic
Supported Models: snom PA1 series
Step 1: Upgrade to the Required firmware
Step 2: Factory Reset the IP Phone
Step 3: Provision the phone
Local LAN or SBC: Provision via Plug'n'Play
Remote phones: Provision with the Manual Provisioning Link
Step 4: Extended Phone Configuration
Known Limitations
Supported Models: snom PA1 series
● snom PA1
Step 1: Upgrade to the Required firmware
Ensure that the phone is running on the required firmware by 3CX. In case the device needs manual updating
download the latest distributed required firmware by 3CX here. Read how to check what firmware the phones
are running on and how to upgrade them in this guide:
Step 2: Factory Reset the IP Phone
Before provisioning the IP phone, the phone must be brought back to factory defaults in case the device has
residual settings of a previous configuration. To reset the device read our
Series
document.
Step 3: Provision the phone
https://www.3cx.com/sip-phones/snom-pa1/
How to Auto Provision a snom PA1 for 3CX version 15
How to manual upgrade snom IP
phones.
How to Factory Reset snom PA1
1/3
Advertisement
Table of Contents
Related Manuals for Snom PA1 Series
Summary of Contents for Snom PA1 Series
- Page 1 2/28/2019 How to Auto Provision a snom PA1 for 3CX version 15 How to configure Snom PA1 for 3CX This guide applies to v15.5 only. On this topic Supported Models: snom PA1 series Step 1: Upgrade to the Required firmware...
- Page 2 2/28/2019 How to Auto Provision a snom PA1 for 3CX version 15 There are several methods to provision a phone: ● Plug & Play - For phones on the local LAN or behind the 3CX SBC. ● Manual Provisioning - For phones on remote networks that will connect directly to 3CX and use STUN.
- Page 3 2/28/2019 How to Auto Provision a snom PA1 for 3CX version 15 5. Click “OK”. The phone will configure automatically and will reboot to finalize the setup. Remote phones: Provision with the Manual Provisioning Link Due to the lack of a user input/screen, the device can not be configured via RPS. In this case use the Manual Link Provisioning method outlined here.
Need help?
Do you have a question about the PA1 Series and is the answer not in the manual?
Questions and answers