Summary of Contents for Rhyas RH320
- Page 2 TECHNICAL SPECIFICATION CHARGING THE BATTERY Model:- RH320 1.Set the mode switch to “CHARGE”. Voltage:- 230V AC 50Hz 2.Set the required rate of charge by using Charging Capability:- 12v & 24V Batteries the charge power switch positions, (see Max Charge Current:- 45Amps main panel).
- Page 3 STARTING WITH A FLAT BATTERY FUSES 1.Check the vehicle manufacturer’s Your Charge & Start is equipped with a handbook for any special instructions. safety fuse which will cut the power to the 2.Ensure the Charge & Start is unit in the following circumstances: disconnected from the mains power a.Overload - too high a current to the supply and connect the POSITIVE (+)
- Page 4 Date: September 2011 Rhyas Products, Unit A Southern Ave, Leominster. England HR6 0QF UK. Subject to change. Document Ref: RH300 Charge & Start 53031 Product code: 53031 Copyright: These instructions are the sole property of Rhyas Products and may not be reproduced.
Need help?
Do you have a question about the RH320 and is the answer not in the manual?
Questions and answers