Summary of Contents for Impact Test Equipment CN600
- Page 1 Masonry Saw CN600 Impact Test Equipment Ltd www.impact-test.co.uk & www.impact-test.com User Guide User Guide...
- Page 2 Impact Test Equipment Ltd. Building 21 Stevenston Ind. Est. Stevenston Ayrshire KA20 3LR T: 01294 602626 F: 01294 461168 E: sales@impact-test.co.uk Test Equipment Web Site www.impact-test.co.uk Test Sieves & Accessories Web Site www.impact-test.com...
-
Page 3: Table Of Contents
CONTENTS INTRODUCTION LIFTING INSTALLATION WORKING MATERIALS MAINTENANCE STORAGE DISPOSAL ELECTRIC LAYOUTS... -
Page 4: Introduction
1. INTRODUCTION 1. These operating instructions are intended for the user of the machine and the person responsible for safety procedures. Keep a copy near the machine. 2. Only skilled operators should use the machine, after studying this manual. 3. The operator who will use the machine must be trained in the correct operation of the unit, above all about the safety device that must be always assembled and checked daily;... -
Page 5: Installation
3. INSTALLATION 1. The cutting machine has the cutter block arbor (28) that has been lubricated is packed with protective soft materials (carton or sponge rubber) and band-wrapped with cellophane and adhesive tape. The machine does not usually suffer damage in transit because of its strong frame. However, after unpacking, please check that the machine is upright and undamaged. -
Page 6: Working Materials
; the push is characterized by a varying strength depending on the thickness of the material. 2. Do not under any circumstances try to use this machine to cut wood, polystyrene, glass wool etc. 3. Technical features: CN600 BLADES UP Dia. 450... -
Page 7: Use
5. USE 1. Before operation check that the carriage moves freely and that the tank is clean so that the pump is able to supply the right quantity of water to the disk for cooling. 2. The operator must wear proper protective equipment, such as gloves, protective shoes, safety glasses, earp defenders etc. -
Page 8: Storage
The electric pump (44) is positioned on the tank, and it has a shaft of 120mm. Its extremity must always be in the water, and its level will always be same as the tank level. 5. At the end of every working day: - clean the water tank and the pump;...