Nemaxx FCA35X Original Operating Instructions page 12

STEP 6
Remove the restraint straps from around the awning unit if not already done so.
Open the awning (by pressing the "UP" (▲) button on Remote Control) until the arms are
at their maximum extension.
Retract back a little to keep the fabric cover tight.
STEP 7
ADJUSTMENT OF TILT ANGLE
The awning is supplied with the most ideal pre-set angle of tilt.
The angle can however be adjusted by loosening the 4 x 17mm locking nuts on the sides
of the arms and then turning with a spanner the 2 x 13mm jack bolts to the desired angle.
Once adjusted, securely tighten up the 17mm Locking Nuts.
DO NOT operate this awning unless the arms are perfectly level as this will cause
premature damage to the frame and arms.
Push the plastic bolt caps on top of the bolt heads to protect the bolts from weather
corrosion. Your awning is now ready for use.
After use, always remove the emitter from the unit and store in a dry safe place.
DO NOT ALLOW CHILDREN TO PLAY WITH THIS AWNING
EN
Locking nuts
Jack bolt
12
KEN001VKM
v03 • 07.09.2017