Corbin CA-RT-10 Manual

Part Number:
Description:
Dual Tour Saddle & Trunkrest
Fitment:
2010 Can-Am Spyder RT
Revision:
6
Tools Required
10mm Socket wrench
T-30 Torx wrench
T-20 Torx wrench
Flathead screwdriver
NOTE: We recommend the use of Loctite® or
similar thread lock product when assembling parts
on your motorcycle.
1. Start by removing the stock seat. To do this,
you need to remove the trunkrest. Open the
trunkbox and remove the two bolts on the top,
using a T-20 torx wrench (Figure 1). Next remove
the three bolts on the inside of the trunk, using a
T-30 torx wrench (Figure 2). Close the trunk lid
and pull the trunkrest out (Figure 3).
2. Remove the two hinge bolts behind the seat
using a 10mm socket wrench (Figure 4). Do not
lose the nuts and bolts because you will re-use
them to secure the Corbin saddle (Figure 5).
3. Lift the stock saddle up and disconnect the
shock from the seat by pulling out the metal clip
with a flathead screwdriver (Figure 6).
4. Raise the seat into a upright position and
disconnect the sensor (Figure 7).
5. Remove the seat, making sure you do not lose
the aluminum spacers (Figure 8).
6. Remove the ABS rear braking sensor system
on the stock seat, using a T-30 torx wrench
(Figure 9).
CA-RT-10 (E) & CA-RT-10-TR
1 #CB-PWR-HRN-36 CA-RT Wiring harness
1 #SMALL-FACC Small fuse adapter
FIG 1
FIG 3
FIG 5
Parts List
FIG 2
FIG 4
FIG 6