HSS Hire Smithlight LED Operating & Safety Manual

must press the Black main power switch for complete
shutdown.
To close the Smithlight, push the button In the middle of
the handle, hold in, lower the lid of the light until the lid
meets the top of the light body, release button, and you will
hear and feel the locking pins go into place. It is then locked
in the closed position allowing you to carry the Smithlight
to your next job.

EQUIPMENT CARE

Never push the equipment beyond its design limits. If it
will not do what you want with reasonable ease and speed,
assume you have the wrong equipment for the job. Contact
your local HSS Hire for advice.
If the bulbs fail, do not attempt to replace or fix them,
contact your local HSS Hire for advice.
If the battery is discharged it must be recharged within
24 hours to avoid battery damage.
Keep the equipment clean - you will find this less of a
chore if you clean it regularly, rather than wait until the end
of the hire period.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.

FINISHING OFF

Switch the lamp OFF, disconnect battery charger from
mains and it lower down.
Give the unit a final clean up ready for return, to your local
HSS Hire.
... have you been trained
The law requires that personnel using this type of equipment in
the workplace must be competent and qualified to do so. Training
is available at HSS Training Solutions
0845 766 7799
...any comments?
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments or
write to the Safety Guide Manager at the address below
e-mail: safety@hss.com
©HSS Hire Service Group Ltd 2011 No. 805/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
Operating & Safety Guide 805 Operating & Safety Guide 805
Smithlight LED
Smithlight LED
Easy to set up portable light. Doesn't
require generators, power extension
leads etc; cutting down set up times
and running costs
Code 57454
805/01 805/01