Advertisement
Number of Sheets to be Inserted
1 - 10
5 - 15
10 - 25
25 - 50
40 - 75
65 - 100
90 - 125
115 - 150
Use only as a guide for 20# bond paper. The number of sheets will vary with
the thickness of text paper being bound. The best fi t will be obtained by
measuring the thickness of the document.
Heating
Throat
Spine Width Required
⁄
"
1
16
⁄
"
3
32
⁄
"
1
8
⁄
"
1
4
⁄
"
3
8
⁄
"
1
2
⁄
"
5
8
⁄
"
3
4
Cooling
Rack
Hard Cover Cycle Button
Soft Cover Cycle Button
Binding & Operating Instructions
1.
Plug unit into a standard 100 volt grounded outlet.
2.
Turn the ON/OFF switch, which is on the back right side of the
unit. The red POWER indicator will light up. After approximately
2 minutes, the unit will beep and both green lights will light. The
Pro-Bind 1000 is ready for use.
3.
Jog documents and select the appropriate cover spine capacity.
4.
Place the documents to be bound into the cover.
5.
Place cover, spine down, onto the Pro-Bind 1000 heating plate.
Make sure cover spine rests squarely on the heating element.
6.
Press the Start Button on the left side for soft covers and on
the right side for hard covers. The heat cycle will start and the
associated green light will blink while binding.
7.
At the end of the heating cycle an audible tone will alert that the
binding cycle has fi nished and the green light will go back to solid
green. Remove the document from the Pro-Bind 1000.
8.
Jog document and place on the cooling rack attached to the back
of the unit. Do not lay bound document fl at to cool; always cool
with spine on a fl at surface.
9.
Repeat process until all documents are bound.
10.
After 3 minutes of non-use, the Pro-Bind 1000 will switch into
energy saving mode. The unit will make two audible beeps and the
red POWER light will begin to blink.
11.
To resume binding, push the start button (either side). The POWER
light will go solid and the unit will begin to reheat.
12.
When the unit is ready to bind an audible tone will sound and the
green lights will light again.
13.
For hardcover binding heat on the hard cover cycle and place
hardcover into the Hardcover Crimper to cool.
Binding Tips
JOGGING - Jog each document before placing it in the cover to ensure
all pages have contact with the glue strip. Failure to jog or poor jogging
of the document can produce partial or weak binds.
MAINTENANCE - It is recommended to occasionally wipe the unit
with a dry cloth and to keep it dust free. The heating plate should also
be kept free from dust and excess glue. To remove excess glue from the
heating plate simply heat unit fully, upon the end of the cycle unplug
the unit and using a dry paper towel, wipe off heating plate. Be careful
not to touch the heat plate directly it will be HOT.
Advertisement
