Quantum Ecoelec QE-7018 User Instructions

Ceramic space heater with remote control, room heater

Thank You very much for your custom

You have purchased one of the most modern and reliable electrical appliances currently available,

which we know will give you long and reliable service.

As with all electrical appliances, it is important that all safeguards are followed. We therefore ask

you to read through these instructions carefully and to keep them in a safe place for

future reference.

This manual can be downloaded from the Quantum eco-elec website at

www.quantum-ecoelec.com/support

THE CONTENTS OF THE BOX

Along with these instructions the box should also contain the following items

The most important item is a QE-7018 wall heater

1 off Remote control

2 off No8 Woodscrews, 35 mm long

2 off plastic Rawlplugs for fixing the heater to a concrete or brick wall

If there is anything missing please call 05602-045420 between 8:00am and 4:00pm Mon to Fri

and we will do our best to replace the items as soon as possible, or you can email us at:-

support@quantum-ecoelec.com

CONFORMITY

This product is CE, TÜV & RoHS marked and conforms to these standards.

Environmental Protection

European directive 2002/96/EC on waste electrical and electronic equipment

(WEEE), requires that old household electrical appliances

must not be disposed of in the normal unsorted household waste.

Please recycle where facilities exist. Check with your local Authority on recycling advice and

disposal sites in your area.

USER INSTRUCTIONS

CERAMIC SPACE HEATER WITH REMOTE CONTROL

ROOM HEATER

MODEL No. QE-7018

QE7018

Table of Contents

Do you have a question about the QE-7018 and is the answer not in the manual?

Page 1 THE CONTENTS OF THE BOX Along with these instructions the box should also contain the following items The most important item is a QE-7018 wall heater 1 off Remote control 2 off No8 Woodscrews, 35 mm long 2 off plastic Rawlplugs for fixing the heater to a concrete or brick wall...
Page 2 INSTALLATION INSTRUCTIONS ALL ELECTRICAL WORK SHOULD BE CARRIED OUT BY A COMPETENT ELECTRICIAN 1 Decide on a suitable location. 2 Mark the position for the 2 No.8 Woodscrews. (supplied) 3 Fit the screws leaving the screws protruding 15mm from the wall. 4 Mark the position on the wall for the 13A Fused Spur connection.
Page 3 OPERATION There may be a trace of smoke or odour during the first few minutes of initial use or when the unit has not been used for a period of time. This is quite normal and will quickly disappear. FROM THE FRONT PANEL The unit is in standby mode (POWER light will be ON) while the FUSED SPUR is switched on.
Page 4 Supply Voltage 220 - 240V Power rating 10A MAX Frequency 50Hz Output Power 1000 or 2000 Watts Timer Control 0.5 – 7.5 Hours Remote Control Range 7 metres MAX Remote power source 2 x AAA Batteries © QE-7018 ISS.2 QE7018...