Profoto Lantern 1,7’ Flat Manual page 2

Lantern
Lantern 3' & 4' flat manual
1. parts
b f
a e
c
g
d h
2. InsertIng rods Into speedrIng
• connect each rod B and rod a.
• Insert the other end of rod B into a hole in the speedring.
• the second rod should be inserted into the opposite of the first.
the third rod goes in diagonal position and the last one in the opposite of the third.
• skeleton of pancake is completed.
Product no Description
a 46 40 95 rod a for hr lantern 3'
46 40 96 rod B 4-in-1 set for hr lantern 3'
b
46 41 73 translucent body for hr lantern 3'
c
d 46 41 74 Black cover for hr lantern 3'
e 46 40 97 rod a for hr lantern 4'
f 46 40 98 rod B 4-in-1 set for hr lantern 4'
g 46 41 75 translucent body for hr lantern 4'
h 46 41 76 Black cover for hr lantern 4'
3. attachIng Body, cover and then completed
• cover the body over the skeleton.
• It might be neccessary to remove one rod to be able to fit the body.
• cover goes on top of the body.
• Zip it up as much as needed.
• each four side of cover can be open, rolled up and fixed using
attached velcro.
this product can be modified for better quality and function without prior notice