Summary of Contents for Exerpeutic Heavenly
- Page 1 9400.1-102617 The specifications of this product may vary from photo and are subject to change without notice.
- Page 2 PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE. STOP. Contact customer service if you have any questions regarding assembly or proper operation of the machine. Email us at: Service@paradigmhw.com Or call us at: 1-844-641-7921 Hours: 8:00 am to 5:00 pm (PST) Daily...
-
Page 3: Table Of Contents
TABLE OF CONTENTS Page # Service Label Placement Safety precautions Overview drawing Parts list Assembly Adjustments Storage and Transporting Maintenance Instructions Warranty Part request form... -
Page 4: Service
SERVICE IMPORTANT: FOR NORTH AMERICA ONLY For damaged or defective product, questions, replacement parts or any other service support, please contact our customer service department by the below methods: For The Best Service, please Email: service@paradigmhw.com Response Time: 1-2 Business Days Emailing us with the information above will be the best method to receive a response during peak business hours Website:... -
Page 5: Label Placement
LABEL PLACEMENT... -
Page 6: Safety Precautions
SAFETY PRECAUTIONS Examine the Massage Table for damage before each use. Maintain the table periodically. Make sure all screws are secure and the cable has not deteriorated or frayed. Make sure there are no cracks in the wood structure. Use the Massage Table on a level surface. Do not use alcohol based cleaners when cleaning the vinyl. -
Page 7: Overview Drawing
OVERVIEW DRAWING... -
Page 8: Parts List
PARTS LIST Part# Description Q’ty Part# Description Q’ty 01 Front Bed Frame 19 Short Cable 02 Rear Bed with Frame 20 Long Cable 03 Upper Buckle 21 Self -Tapping Bolt M6x65mm 04 Lower Buckle 22 Armrest 05 Handle 23 Face Plug Round Head Self Tapping Rubber Foot Pad Screw M3x20mm... -
Page 9: Assembly
ASSEMBLY Remove table from bag. Release the Upper/Lower Buckles (3/4) and then open the table so that it is standing on the side with the Rubber Foot Pads (6). Take out the Face Cushion (18), Side Arm Supports (35), and Armrest (22), from underneath of the table. - Page 10 ASSEMBLY Lift one end of the table and pull out to open table fully. Both sides of the massage table must be parallel with the floor before anyone gets onto the table. Loop the Armrest (22) straps onto the Face Frame (09) rods.
- Page 11 ASSEMBLY Attach the Face Cushion (18) onto the Face Frame (9). Insert the posts of the the Side Arm Supports (35) into Frame Plugs (36) on the side of the Front Bed Frame (1).
-
Page 12: Adjustments
ADJUSTMENTS Adjusting the angle of the Headrest Pull the lever on the Face Frame (9) and then adjust the Headrest to the desired angle. Return the lever to the locked position after adjusting the angle. TIP: Turn the lever clockwise before locking to increase grip of the lock that holds the headrest angle. -
Page 13: Storage And Transporting
STORAGE Lay the table on its side. Place the Short/Long Cables (19/20), Face Frame (9), Face Cushion (18), and Side Arm Supports (35) on the underside of the table before closing it. Fold the Lower/Upper Legs (11/12) flat against the table and bring both sides together to close the table. -
Page 14: Maintenance Instructions
MAINTENANCE INSTRUCTIONS You should check your massage table for any kind of wear and tear before each and every use. Check the legs, bed and cables for wear and tear. Replace damaged and worn components immediately. Keep all damaged equipment out of use until it is repaired. Maintain the table periodically. -
Page 15: Warranty
WARRANTY MANUFACTURER’S LIMITED WARRANTY Paradigm Health & Wellness warrants to the original purchaser that this product is free from defects in material and workmanship when used for the purpose intended, under the conditions that it has been installed and operated in accordance with Paradigm’s Owner’s Manual. -
Page 16: Part Request Form
PART REQUEST FORM Paradigm Health & Wellness, Inc. EMAIL THIS FORM WITH YOUR RECEIPT OF PURCHASE TO Service@paradigmhw.com* NAME:___________________________________________________________________________ ADDRESS:_______________________________________________________________________ CITY:________________________ STATE:_____________ ZIP:_______________________________________ TELEPHONE: (Day)_______________________________________________________ (Night)_________________________________________________________ SERIAL#:________________________________________________________________________ MODEL#:________________________________________________________________________ PURCHASE DATE:___________________________________________________________________________ PLACE OF PURCHASE:______________________________________________________________________ PART # DESCRIPTION “YOUR ORDER WILL BE PROCESSED WITHIN 3 BUSINESS DAYS” This form can also be faxed to #: 626-810-2166...