Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zeus MST-8000+
Summary of Contents for Zeus MST-8000+
- Page 1 Battery Analyzer MST-8000 + Instructions...
-
Page 2: Table Of Contents
Zeus Technology Co., Ltd. Shenzhen 1.Appearance............................. 3 2.The Boot............................4 3.Functional Test..........................5 a. Battery test...........................5 b. Starting System Test........................7 c. Charging System Test......................... 7 d. Maximum load test........................8 5.System Settings..........................9 a. Language Settings........................9 b. Time Set............................9... -
Page 3: Appearance
Zeus Technology Co., Ltd. Shenzhen I. Appearance 1. Storage battery tester host 2. Display Interface: Using 320 * 240 color LCD screen that can display different functions and measurement data 3 Left ◀: Switch pages or set of data 4 Right ▶: Switch pages or set of data 5 on the key ▲: Selection function... -
Page 4: The Boot
Zeus Technology Co., Ltd. Shenzhen 2.The boot 1. connecting wiring and battery battery tester between. Red clip connect the battery positive, black clip connect the battery negative. If red or black clip clip connection is not reliable, the following diagram interface 1.0 and Figure 1.1 shows, there is a problem at this time need to disconnect to reconnect to... -
Page 5: Functional Test
Zeus Technology Co., Ltd. Shenzhen 3.Functional testing a. Battery Test After the normal boot, press any key to enter the main menu, as shown in Figure 3.1.0. 图 3.1.0 Press "▲ ▼" button, select "1 battery test" press <Enter> key to enter the next one, if the battery voltage is too low (less than 11.5V) will be prompted... - Page 6 Zeus Technology Co., Ltd. Shenzhen 图 3.1.3 图 3.1.4 If the test result lower right corner of the interface with an icon of the printer, press <Enter> key to print the test results, you can enter the test results before printing models, the interface shown in Figure 3.1.5.
-
Page 7: Starting System Test
Zeus Technology Co., Ltd. Shenzhen b.Starter system test In the main menu (Figure 3.1.0) Select option 2 (starter system testing), and 图 3.2.0 press <Enter> key to enter the starter system test interface (Figure 3.2.0 below). prompted display interface to operate. After starting the engine to wait around for about 15 seconds to read the test data (minimum voltage value). -
Page 8: Maximum Load Test
Zeus Technology Co., Ltd. Shenzhen Prompted interface prompts: 1, first start the car, the car starts to wait for about 15 seconds, to ensure stable operation of the engine has been 2, press <Enter> to start testing, enter the test screen (Figure 3.3.1) 3, the engine speed is gradually increased to 2000r / min. -
Page 9: System Settings
Zeus Technology Co., Ltd. Shenzhen 5.System Settings a. Language Settings In the main menu (Figure 3.1.0) Select option 5 (System Settings), then press <Enter> key to enter system settings selection interface (shown in Figure 3.5.0). 图 3.5.2 图 3.5.1 Select the language setting, press <Enter>... - Page 10 Zeus Technology Co., Ltd. Shenzhen arrow keys "◀ ▶": Select the object to change. "▲ ▼": adjust the value. Press <Enter> to save the changes after modify, press <Esc> key to discard changes...