• Read instructions before using this device. • Clean Avya before use. (See cleaning instructions) • Clean Avya at the end of each day of use and store properly. • This is a single patient device. Do not allow multiple patients to use the same device.
• Keep the device out of the reach of infants and children. Children should use Avya only under an adult’s supervision. • We recommend using Avya with our compatible aqueous solution. DESCRIPTION OF DEVICE AND ACCESSORIES 1) Main unit. 2) Mouthpiece. 3) Temperature increase button.
Steam Inhaler main unit. Make sure to connect firmly so that you hear a “click” sound (Fig. 1) To remove the water tank from the Avya main unit, press the button and pull water tank upward simultaneously (Fig.
INSERTING BATTERY PACK Be sure to insert battery pack as indicated on the inside door of the battery compartment. With normal use, a completely charged battery pack will power Avya for about 2 hours. Complete battery recharge time is approximately 3 hours.
Page 6
Note: Before using the battery pack, the plastic pole protector cover on battery pack must be removed. Note: ONLY use Avya’s supplied battery pack for the device. Tampering with the battery pack will void the product warranty. We recommend replacing the battery pack after one year of regular use.
AC ADAPTER OPERATION Note: Before using the AC Adapter, always check the data plate on the bottom of Avya device to ensure that the voltage and current indicated on the unit correspond to the voltage and current available. Connect the AC adapter only to the mains voltage listed on the type plate.
Note: Before use, ensure the device and accessories are at room temperature. Preparing Avya • For hygienic reasons, it is imperative that Avya and accompanying accessories are cleaned after every use. For details, see Section Cleaning. Filling the Water Tank •...
Page 9
Fig. 5 Fig. 6 <45 Fig. 7 LED indicators Increase temp LOW ~ 40 MEDIUM ~ 45 HIGH ~ 55 COOL Decrease temp...
Page 10
Note: The Avya Steam Inhaler device and accessories are intended for multiple use. Before you clean the device, always switch it off, unplug it and let it cool off. The Avya main device and the accessories used must be cleaned after each use.
Page 11
Fig. 8 Fig. 9 Note: NEVER ATTEMPT TO CLEAN THE MESH WITH ANY FOREIGN OBJECT, THIS COULD DAMAGE THE MESH AND WATER TANK. The unit will not operate with a damaged mesh.
Cleaning the 4 stainless steel contact poles: Use a cotton swab dampened with water to clean the stainless steel contact electrodes on the Avya device (4 poles total - 2 poles on the main body and 2 poles underneath the water tank).
TROUBLESHOOTING Please refer to the table below to troubleshoot any problems. Low atomization. • Check to ensure there is water in tank. • Make sure water tank is firmly in place. • Clean mesh as recommended in the instructions. • Clean electrodes on control unit and water tank. Power light goes out immediately after powering on.
Leakage from outlet of the mouthpiece. • Open the residual port located on the bottom of the unit to allow accumulated water to release. If your Avya Inhaler still does not function properly after troubleshooting, follow warranty service instructions. TECHNICAL SPECIFICATIONS...
WARRANTY AND SERVICE The Avya Steam Inhaler unit is warranted for one year from date of purchase against defects in manufacturing. All warranties are based on normal usage. The warranty does not cover wearable accessories. This warranty covers normal usage, failure to adhere to...
Need help?
Do you have a question about the AVYA and is the answer not in the manual?
Questions and answers