Summary of Contents for NASA Marine Meteoman
- Page 1 DESIGNED AND MANUFACTURED IN ENGLAND Meteoman Barometer NASA MARINE LTD RoHS 2002/95/EC www.nasamarine.com...
-
Page 3: Installing The Display
Cut a hole in the panel 103mm high by 143mm wide. Unscrew the wing nut from the rear of the Meteoman and take off the mounting clamp. Fit the 'O' ring in the groove on the rear and place the unit in the hole in the panel. - Page 4 Plug the short cable into the socket on the rear of the Meteoman display unit. The masthead sensor is a generic device and can be used independently of the Meteoman.
- Page 5 SECTION 2 Using the NMEA masthead sensor independently to the Meteoman. (This procedure is not necessary when using the sensor with the Meteoman). Mount the sensor as described in the installation instructions. Connect the screen wire to the negative supply and the red wire to 12 volt positive supply.
- Page 6 NMEA wind sensor? Yes. Modern Clipper wind speed instruments have an NMEA output which can be connected directly to the Meteoman to give wind speed and direction. The Clipper wind does not have a temperature sensor so the Meteoman will display the internal temperature.
- Page 8 Prior to unpacking this instrument read and fully understand the installation instructions. Only proceed with the installation if you are competent to do so. Nasa Marine Ltd. will not accept any responsibility for injury or damage caused by, during or as a result of the installation of this product.