Tres 900 Troubleshooting Manual

tres900 Troubleshooting Guide
Q: Training
1. Have you taken an online webinar from one of our staff
2. Have you read thru the install guide and understand everything written
3. Did you unpack and test the unit in your facility prior to installing at the site
Q: Confirm that the unit is operating properly
1. Confirm the beeper is audible with one BEEP when power is first applied.
2. Confirm the beeper is audible when a good tag is presented with a steady BEEP.
3. Check that the
supply, the warranty is based on its use.
4. Check the voltage at the Reader pigtail cable, if you under cabled the voltage drop would
be too much to power up the Reader.
Q: Reader just beeps and keeps beeping, about 3 x per second
1. If a week constant audible BEEP when power is applied and no tag presented, means
reader is either damaged or not enough current is being supplied.
2. Are you using the tres supplied power supply and is it located at the end of the pigtail
3. Not enough power from the power supplier, Insufficient power,
www.tresrfsolutions.com
RED and BLACK wires are installed correctly to our supplied power
Transponder and Reader Engineered Systems, Inc
217 Fulton Court ▪ Peachtree City, GA 30269 ▪ 888.574.tres (8737)
®
Page 1