Advertisement
R
S Y S T E M S
Mira Connect Integration
Kramer VP Series
Video Switcher
The Kramer VP Series scaling presentation video switchers can be controlled with Mira Connect™, Aveo Systems' smart
control appliance.
To integrate the Kramer VP Series with Mira Connect, add a Kramer Video Switcher
to the room in Mira Portal (https://mira.aveosystems.com), select the model, and
enter the IP address of the system and press 'add equipment'. Mira Connect will
connect to the Kramer VP Series and, if the IP address is valid, Mira Portal will show
the equipment status as a green circle once the Kramer VP Series device has been
validated on the network.
Important information about the integration is summarized below.
Control Interface
The Kramer VP Series is controlled via TCP over port 5000.
Mira Connect switches audio and video together (audio follows video) when changing video inputs to outputs.
Models Supported
VP-778, VS-622DT, VP-558, and VP-445. Additional VP series products can be supported.
Software Versions
Tested with a VP-778 with device firmware v3.00.07.36759
Configuration Steps
On the Mira Portal Video Inputs tab, enable the desired inputs on the video switcher, and enter labels and optional
descriptions, to create the video display menu for source selection.
Equipment
ADD
Kramer Video Switcher
192.168.80.131
Firmware: 3.00.07
Mira Connect
S Y S T E M S
Aveo Systems, Inc.
1791 West Oak Parkway
Suite 8
Marietta, GA 30062
Phone: +1.678.653.7090
Fax: +1.844.fax.aveo
Email: info@aveosystems.com
www.aveosystems.com
R
Advertisement
Table of Contents
Summary of Contents for Avea Kramer VP Series
- Page 1 Mira Connect Integration Kramer VP Series Video Switcher The Kramer VP Series scaling presentation video switchers can be controlled with Mira Connect™, Aveo Systems’ smart control appliance. To integrate the Kramer VP Series with Mira Connect, add a Kramer Video Switcher to the room in Mira Portal (https://mira.aveosystems.com), select the model, and...
- Page 2 Mira Connect Integration with the Kramer VP Series When connecting an output from a video switcher to a display, add the display to your equipment and for the desired input on the display, select ‘Use Sources Connected to Other Equipment’ and then select the video switcher and the desired output from the video switcher that is connected to that input on the display.
Need help?
Do you have a question about the Kramer VP Series and is the answer not in the manual?
Questions and answers