Table of Contents
Advertisement
2Fn + (1-8) output keys for F1 - F10, also used for macro, can be in control
panel Settings.In the control panel set up corresponding application
procedures and opens, through the press this key combination can be
directly to activate the application.
3Fn + upper-left corner green button, can be enabled keyboard backlighting.
4Fn + top-r red buttons, it may prohibit keyboard backlighting.
5Fn + ENT permitted use touch-screens.
6Fn + LEFT reduce screen backlighting brightness, Fn + u-right increase
screen backlighting brightness.
7Fn + DOWN the key value VK_VOLUME_DOWN and reduce the volume,
Fn + UP the key value VK_VOLUME_UP that increasing the volume, Fn +
ESC key/value VK_VOLUME_MUTE muting switch out.
8Fn + # out the blank space key
9Fn + TAB out key value ALT + TAB (system default can mix the task
manager).
Chapter 2 Getting Start
2.1 Installing & Changing Battery
1. Be sure that the Terminal is turned off.
2. Unlock the Battery Cover.
3. Remove the Battery Cover.
4. Insert battery in the battery compartment with the tie on
9
Advertisement
Table of Contents
