MPM RAPID mini User Manual

Applications:

Cylindrical grinding -- - taper grinding -- - form grinding -- -
polygon grinding -- - plunge-cut grinding -- - smallest diameter grinding
On your surface grinding machines!
1. Set the RAPID mini on the magnetic table of the surface grinder. Adjust the right-angled
groundplate to the stop ledge of the magnetic table and switch the magnet on.
2. Place the workpiece under the centre of the grinding wheel.
3. Select with  or  the sense of rotation and spindle start.
4. Determine the highest point of the workpiece by moving the machine-table.
5. When grinding cylindrical and taper parts, the timing belt must be tightened and the index bolt
must be unlocked!
Switch the motor on and let the workpiece rotate.
6. When grinding surfaces or polygons, the timing belt must be loosened.
For this, the clamping screw for the motor bracket must be released.This screw is on the
bottom of the block. Then you can move the motor along the slot.
7. The motor must be switched off and the index bolt must be locked.
Observe safety
instructions:
 I
N SLEWED POSITION
ONLY GRIND TOWARDS
THE GAUGE BLOCK
 N
EVER REMOVE THE
TIMING BELT COVER WHEN
MACHINE IS IN OPERATION

Maintenance:


The RAPID mini grinder is sealed on the front and rear side with a shaft-sealing ring for
splash-water protection.
In case of heavy coolant use we recommend an additonal cover.

Cleanness and good care preserve the precision of the RAPID mini grinder .
E106015.docx
 Micro Präzision Marx GmbH  D-91056 Erlangen  09131-9056-0  09131-9056-600
User Manual
RAPID mini precision grinder

Mode of use

!
ED: 16.01.17 SD: 02.12.19 Dieter Marx - 1/2 -