Table of Contents
Advertisement
All manuals and user guides at all-guides.com
APSNUG.book Page 18 Tuesday, May 4, 1999 11:13 AM
18
Chapter 1
Getting Started
Error Message
Pointing Device Error
Pointing Device Interface Error
Pointing Device IRQ Conflict
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
IDE Drive 0 / 1 / 2 / 3 Auto
Detection Failed
Floppy Drive A Error
Floppy Drive B Error
Floppy Disk Controller Error
CPU Clock Mismatch
Serial Port 1/2 Conflict
Corrective Action
Reconnect or replace the pointing
device.
Check the pointing device interface
circuit.
Enter Setup and change the IRQ setting
of the PS/2 mouse.
Replace the disk drive or the HDD
(hard disk drive) controller. Check the
HDD cable connections and IDE
settings in Setup.
Replace the disk drive or the hard disk
drive controller. Check the HDD cable
connections and IDE settings in Setup.
Check if there is no floppy disk in the
drive. If there is, turn off the system
and check the cable connections. If the
connections are okay and the error
message continues to show, replace
the floppy drive.
Check the floppy drive cable and its
connections. If the cable is good and
properly connected, the floppy disk
controller may be the problem.
Change the floppy disk controller or
disable the onboard controller by
installing another add-on card with a
controller.
When the user changes the CPU
frequency, this message will be shown
once. Then the BIOS will adjust the
CPU clock automatically.
Change the onboard serial port 1/2
address in Setup or change the add-on
card serial port address.
Advertisement
Table of Contents
