Vestamatic VRS Luxsensor S Installation And Operating Instructions

„ For inside mounting on the window pane
„ Transmit commands combined with Touch Control VRS
– Contact a professional electrician to install the control system.
– Check the control system for signs of mechanical damage af­
ter unpacking. If you notice any shipping damage, do not start
up the control system and notify your supplier immediately.
– The control system should only be used for the purpose spec­
ified by the manufacturer (refer to the operating instructions).
Any changes or modifications thereof are not permissible and
will result in loss of all warranty claims.
– If the control units or the connected sunshade cannot be oper­
ated without presenting a hazard, it must be switched off and
prevented from being switched on unintentionally.
– This device contains a pollutant battery. The end user must re­
cycle all used batteries in accordance with regulation 91/157/
EWG. Disposing of the batteries in household waste is strictly
forbidden.
Radio frequency:
Modulation:
Power supply:
Protection degree:
Programmable range:
Operating temperature:
Range in buildings:
Dimensions (L × W × H):
Weight:
Conformity:
This product conforms to the basic requirements of the R&TTE Directive
1999/5/EC. The Declaration of Conformity can be found on the web page:
www.vestamatic.com.
The Lux sensor can only be used in connection with Vestamatic controls for
the wireless transmission of control commands.
The manufacturer will not assume any liability for damage caused by im­
proper or inappropriate handling.
The Lux sensor periodically measures the current brightness value. If the
brightness exceeds or falls below the user­defined threshold, the sensor
transmits a movement command to the control.
If the brightness value is over the threshold for one minute, the DOWN
command is transmitted. If the brightness value is below the threshold for
16 minutes, the UP command is transmitted.
© Vestamatic GmbH
G
VRS Luxsensor S
Art. nr.:
01180000
Short description
Safety precautions
Technical data
868 MHz
FSK
1 × 3 V­Battery, CR 2032
IP 50
2 kLux to 60 kLux
0°C (32°F) to +70°C (158°F)
approx. 30 m
Ø 41 × 13 mm
13 g
p
Conformity
Functional description
VRS Luxsensor S
Lux sensor in Vestamatic Radio System (VRS).
Installation and Operating Instructions
Installation
1. Stick the adhesive ring on the outside of the transparent casing.
2. Stick the sensor close to the bottom edge of the window onto the cleaned
window glass from the inside.
ATTENTION!
Make sure to install the sen­
sor in a shadow­free position!
The Light Sensor may not be
covered by or located in a
shade place!
Note:
For removing the sensor can simply be taken off the window
pane. Rub off the remainder of adhesive with your fingers before
you stick on a new adhesive ring.
Start-up
1. Fit batteries
Open the casing and insert the battery into the compartment.
2. Setting the threshold.
To set the threshold at which the sensor is to respond, wait until the
current brightness is appropriate. Then push the sensor button (> 3 sec­
onds) until the LED lights up. The current brightness value is saved as
the new threshold.
If you wish to change the threshold, repeat the procedure – the old value
is overwritten.
1/2
G
VRS Luxsensor S
Art. nr.: 01180000
ACHTUNG!
Verdecken Sie den
Sensor nicht.
ATTENTION!
The positive pole
must be visible.
Subject to modifications.