RADIKAL TECHNOLOGIES Swarm Oscillator RT-311 Quick Start Manual

Dear RT-311 customer,
Congratulations on purchasing the Swarm Oscillator RT-311. This module offers possibilities far beyond the
scope of a normal oscillator. Nevertheless, on request it can behave like an analog module. Please refer to
the installation instructions on the back of this manual. After switching it on, it is automatically in this
operating mode, which we call the "MANUAL" mode. The mode LED lights up green to indicate this mode. A
good starting point for the first experiments you can see here:
The output of oscillator 1 is at OUT1. The pitch is controlled by the 1V / Octave input.
Settings you like can be saved directly as snapshots. To do this, use the Big Knob to select a memory
location and press the SNAP-button to the left of the Big Knob. The memory space turns green.
To access the snapshots, switch to Cycle mode. To do this, press the MODE/SHIFT-Button. The LED above
is now red. If the LED lights are moving, set the SPREAD and SPEED knobs to 12:00 as shown in the figure
above. Now you can blend over the different snapshots with the Big Knob.
All further information can be found in our RT-311 manual and workshop videos under the following link:
http://www.joergschaaf.de/wordpress/rt-311-english/