LEDone Distribution Inc L401 Installation Instructions

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. To reduce the risk of electrical shock, turn off power supply before installation or
servicing.
2. This luminaire must be installed in accordance with the NEC or your local electrical
code. If you are not familiar with these codes and requirements, consult a qualified
electrician.
3. If NEMA photo control is installed refer to NEMA Receptacle section for instructions.
4. Verify the availability of necessary tools and incidental material.
TO INSTALL:
Latches
Mounting Bracjet
Bolts
Splashguard
Mounting
Bracket

Installation Instructions

Power Door
Adjustment
Steps
1
LUMINAIRE INSTALLATION
STEP 1:
Unfasten the stainless steel latches.
See Figure 1.
STEP 2:
Open the power door. Power door will
securely hang. See Figure 2.
STEP 3:
Slide fixture on to pole through opening on
2
the rear of housing and through splashguard.
See Figure 3.
STEP 4:
3
To level fixture, use bubble level located
inside housing. Adjust leveling of fixture
from side to side. To level from front to back,
slide pole to different step in upper housing.
Each step changes the angle in 2.5° degree
increments.
Tilt: Stopping at the step marked "0"
provides no tilt. Stopping at the step marked
"+5" provides maximum tilt.
458
L401/L402
527
L403/L404
See Figure 3.