StarVedia D1 Quick Installation Manual

D1 Doorbell Gateway
Setup the doorbell from a Smartphone/Tablet
Supported smartphone system version
iOS iPhone、iPad
Requires iOS 10.0 or later
Android Smartphone、Tablet
Requires Android 5.0 or Later
Download the mCamViewZ+ user manual here.
h t t p : / / w w w . s t a r v e d i a . c o m / d o w n l o a d . h t m l
Download the mCamViewZ+ APP
STEP 1
mCamViewZ+
Scan the QR code to download the software "mCamViewZ+"
from App Store for iPhone
or from Android Play Store for Android mobile.
Power on the Doorbell
STEP 2
Connect the power cable to the Doorbell.
(following the instruction on next page）
After the doorbell is powered on, it is necessary to
complete the WiFi setup within 3 minutes.
Smart WiFi Setup
STEP 3
My Wi-Fi Network My-Home
SSID: My Wi-Fi Network
Password
3
Mobile Connected to 2.4G Hz WiFi
Make sure your iPhone/Android mobile is
connected to a 2.4G Hz WiFi router, this
is a must.
Run the App
Open the App mCamViewZ+, tap the "+"
icon to add the doorbell, choose "setup a
new gateway" and follow the steps on the
App to setup the WiFi connection for the
doorbell.
Generate QR Code
Follow the steps and enter the
WiFi password to generate a QR code.
Quick Installation Guide
Make Sure it Start to Scan
For the first time setup(or after reset), after
powered on, the doorbell will be doing the QR
Doorbell Button
code scanning, the LED is spreading out and in
continuously. ( in other situation, within 3 minutes
after the doorbell is powered on, you can press
the bell button three times in 2 seconds to start
the QR code scanning)
Scan the QR Code
Place your mobile about 10-15cm away from
the doorbell camera lens.
The doorbell will beep when the QR code is
successfully scanned. It will scroll down the
LEDs and start the WiFi connection.
WiFi Connection is Established
When the WiFi connection is established, the
My home
blue LED will stop flashing.
The new icon for this doorbell will be created
on the App.
Log in to the Doorbell
STEP 4
Tap the doorbell icon to log in to the doorbell.
The default administration account is "admin",
the default administration password is empty (leave blank).
After logged in, tap the doorbell icon to play the live video.
Notice : there are two passwords for the doorbell, one is the
administration password, the other one is the video play password. The
default video-play password is "ipcam" (lowercase).
My home

LED Indication

How to do the Reset
Within 3 minutes after the doorbell is
powered on, press the bell button for
more than 5 seconds and release, the
Press more than
doorbell itself will reset to the default
5 seconds
settings and reboot itself.
My home
continued to STEP 5
During startup
LED scroll down slowly
No internet connection
all LED on and off
Scanning QR code
LED spread out and in
Doorbell ringing
LED up and down
Connecting WiFi
LED scroll down fast